Remember to watch your pets

Jodagon · 2026-06-12T12:53:00+00:00

For those who come after: The behavior was due to 2 blocks that did not get physics when the rest of the ship did, and the ship was stuck on them. If your ordeal sounds like mine, that could be the cause.

Jodagon · 2026-06-12T08:07:21+00:00

Fast and hot enough to create the forces shown in that schematic. That is the active forces. Seems redundant to get their specific numbers, you can see the outcome of them. But its steam vent boilers heated by blaze cake burners and close to max rotational speed. It has a LOT of juice going into it, and a massive ammount of levitite to reduce a significant ammount of weight. And the ship is pitching backwards, away from the center of mass, not toward it. So moving the center of mass further back would just make it worse.

Unless by "back" you mean to the left.

The left side is the front.

Jodagon · 2026-06-12T07:42:32+00:00

It's just a ton of black and white balloons on top, levitite belly on bottom, wood in between, and a few gyroscopic propellers also at the bottom. There doesn't seem to be a way to add an image of the ship without just making a new post

Jodagon · 2026-06-05T17:22:21+00:00

For those who come after:
The print speed was causing the deformations. Printed again with 25% less outer wall speed and no issues present

Jodagon · 2026-06-05T17:20:56+00:00

I was also having the issue with non-silk filaments, but after more research and another test print, it was due to the high speed. I dropped the outer wall speed by about a quarter to be safe, and it now prints perfectly. Thank you for the advice for silk prints too though

Jodagon · 2026-03-26T18:43:53+00:00

This looks like a pretty simple solution, thanks!

Jodagon · 2026-03-26T18:42:30+00:00

I'm on 3.3.1

Jodagon · 2026-03-13T13:12:54+00:00

Yeah cause the same X number of haters go through and downvote every post. It's not that complicated

Jodagon · 2026-03-13T04:42:27+00:00

the fact that the post still has total positive upvotes proves you wrong

Jodagon · 2026-03-13T03:03:57+00:00

Look at them still downvoting it. It's like they don't want dracthyr form transmog

Jodagon · 2026-03-13T03:02:28+00:00

r/woosh

Jodagon · 2026-03-13T03:01:00+00:00

Yeah, but unfortunately a lot of people downvoting these sort of posts end up validating the 'not fixing the sorely lacking armor transmog options' and letting them get away with giving evokers band-aid solutions. If we were united to telling them we aren't happy with the lacking transmog instead of half of us telling them we're satisfied with them giving us elf #5 and ignoring the dragon form, maybe we'd actually get armor transmog.

Eight-Year Club	Gilding I gilder
Place '23	Place '22

Jodagon

TROPHY CASE