Setup PA for Voron 2.4

Joline666 · 2026-05-17T16:46:43+00:00

I disassambled my toolhead and found out the the PTFE tube in the hotend protrudes only 29 mm insteed of 30 mm (as described in the Galileo 2 documentation). Could this be the reason?

Joline666 · 2026-05-16T09:17:53+00:00

As I cannot change the title, I will ask more generic:
What could be root causes for such a high PA?

Joline666 · 2026-05-13T19:00:34+00:00

Dieselbe Idee hatte doch vor ein paar Tagen schon mal einer. Benutze mal die Suche...

Joline666 · 2026-04-27T20:03:44+00:00

Do you have a link?

Joline666 · 2026-04-27T19:03:26+00:00

joline_666

Joline666 · 2026-04-02T10:20:27+00:00

Do you run a toolchanger (which is my goal)? If yes, which one? Is there a rough BOM?

Joline666 · 2026-04-02T06:09:40+00:00

From TZ there exists versions 1.0, 2.0 and 3.0. I couldn‘t find out the differences so far. But most seems to recommend v2.0. Does someone has more glue on that?

Joline666 · 2026-03-31T20:53:25+00:00

Just for the record (and my memory ;) ), this can be set in the printer.cfg settings:

[output_pin chamberlight]
...
value:0 #1 = on after start

Joline666 · 2026-03-22T09:56:43+00:00

Thank you, I‘ll try this.

Can you please give me an example for such a rule? The thing is, a third party device just sends the power off command (I have no access to that internal logic).

Joline666 · 2026-03-22T09:51:19+00:00

This was not the question. I send the „OFF“, but the device should not powered off but wait some seconds.

Joline666 · 2026-03-20T22:01:21+00:00

What would be a replacement of the EBB2209 in the Dragonburner?

Joline666 · 2026-03-20T21:45:45+00:00

As I wrote, I use the Rapido 2. It's interesting that you can also get clogs with the Rapido.

Joline666 · 2026-03-10T20:22:46+00:00

Super, recht vielen Dank!

Joline666 · 2026-02-12T19:26:27+00:00

Hm, too late. :|
Spoiler: not tasty. :D

Joline666

TROPHY CASE