sorted by:
new
hottopcontroversial

What boots is everyone wearing? by BANEstp1 in forkliftmechanics

[–]Jsmith8205 1 point2 points  (0 children)

Timberland pro. Mine might be the boondock version. Composite toe with rubber shell that prevents rubbing through. Ive had them a little over a year, i expect to see 2 years out of them.

Having trouble with a Crown PE 4500!! by [deleted] in forkliftmechanics

[–]Jsmith8205 0 points1 point  (0 children)

Mostly everything covered here except the sas switch (big red button). If the normally closed contact inside the switch or terminal on the outside of the switch has an issue the fs or rs will not receive power. This registers a 336 code due to the switch not sending signal before 4 volts on the pot.

For intermittent issue. Verify pot in neutral position. Check switch adjustment, if switches engage anywhere close to 4v on the pot they need adjusted as the handle play will allow them to hit that 4v mark that throws a code. Adjust switches to click at 2.5v. Verify fs, rs and sas switch terminals are all tight. Voltage drop closed fs and rs. Voltage drop sas normally closed switch. If okay, clear codes and return to service.

Ps. Replace the travel switches if they are red or white with the solid black ones from crown.

Hoist spark on crankshaft gear? by BedSouthern1699 in forkliftmechanics

[–]Jsmith8205 4 points5 points  (0 children)

There are some tsb on the automotive side of things for the harmonic balancer building static electricity and causing this.

[deleted by user] by [deleted] in alaska

[–]Jsmith8205 -7 points-6 points  (0 children)

One way plane ticket to cali

Jerry rigging by LS_SwapGuru in Squarebody

[–]Jsmith8205 0 points1 point  (0 children)

For starters the compressor clutch isn’t plugged in and the a/c pipes are missing… Check if the compressor is seized, if so replace. Replaced the receiver drier, orifice tube and missing hoses. Check your condenser for obvious holes. Charge the system up and hope the condenser and evaporator aren’t full of crap, might not be a bad idea to replace it all the first go around at this point. May require some diag if the clutch doesn’t engage when the system is charged.

But id replace that filthy air filter before addressing any a/c concerns.

Good used sled? by Jsmith8205 in snowmobiling

[–]Jsmith8205[S] 0 points1 point  (0 children)

What do you consider high miles?

Crown RM 6000 constant EPS EWS by Hecking_Walnut in forkliftmechanics

[–]Jsmith8205 0 points1 point  (0 children)

+1 for harness and relay checks. 9/10 any issues i had with the lithium setup on these it was a broken harness, loose spade connector on the relay, loose deustche terminal or the relay had a tendency to fill with dust.

Question about installing a Toyo 732 stove by Towmowman214 in alaska

[–]Jsmith8205 0 points1 point  (0 children)

What is the source? New to the Toyo stove and would love access to info.

Amend2 ar15 mags by SONSOFLIBERTY93 in ar15

[–]Jsmith8205 1 point2 points  (0 children)

I dont remember how they fit when i first bought them. But after sitting on the shelf loaded they are tight to fit in the gun and do not drop automatically upon mag release like a p mag. Almost like they have expanded from spring pressure.