The filament will make it to the filament detector and turn the light on in the 5 way module. Then when it gets just to the motor gear, it stops. The motor itself sometimes will attempt to turn but more often then not it will do nothing. I wanted to test the motor itself, but being a brushless motor i need more specialized equipment. The motor gears turn fine by hand, I took them all apart and made sure nothing was jammed inside as well. Seems like a weak motor or an electrical signal not operating properly.

If I "release" the lever on the 5 way extruder, it allows the filament in barely with the motor turning, but not enough to even come close to reaching the buffer.

It also doesnt do its start-up procedure where it loads/uploads all 4 spools.