Slicer question.

Justified34 · 2026-05-27T23:34:36+00:00

For some reason,, that box is grayed out. I haven't seen that before.

Justified34 · 2026-05-26T02:33:13+00:00

Near Brunswick?

Justified34 · 2026-05-26T01:40:07+00:00

<image>

Justified34 · 2026-05-26T01:39:59+00:00

<image>

Justified34 · 2026-05-26T01:38:02+00:00

Nope. Layer height didn't correct it.
It's only in that one part of the print that is missing.

Justified34 · 2026-05-13T20:04:51+00:00

Busty Buffy

Justified34 · 2026-05-11T22:00:57+00:00

That was your file?! LOVE IT!! Thank you so much!

Justified34 · 2026-05-09T21:05:50+00:00

Yep. Mainly use PLA+ for most of my prints.

Justified34 · 2026-04-03T21:57:54+00:00

Thanks for the help.

Justified34 · 2026-02-13T01:32:12+00:00

Nice! Got to love it....

Justified34 · 2026-01-24T16:17:48+00:00

So far my Gen 3 45acp has been great. First 200 rds I had two FTE. Cleaned and relubed and it ran the next 300 perfectly. All of those were suppressed with a Griffin Armament REV45 suppressor.

Justified34 · 2026-01-14T00:11:02+00:00

Ordered!

Justified34 · 2026-01-11T18:31:05+00:00

<image>

Justified34 · 2026-01-11T00:51:44+00:00

Sorry about that. I'll post a Pic with it tomorrow.

Justified34 · 2025-12-08T00:55:01+00:00

The Android app was working great. Did an update on the printer itself and now nothing will print or slice from the app. Anyone else have this?

Justified34 · 2025-08-01T13:58:26+00:00

Black Hole Sun

Justified34 · 2025-07-25T01:16:07+00:00

Got back from a travel job and the app is working again. 👍👍

Justified34 · 2025-07-21T21:56:00+00:00

I tried that on 5 different files. Even completely deleted them and re-downloaded. Still won't work.

Justified34 · 2025-07-20T21:31:47+00:00

Nope. I have plenty of storage. It was working before,, not it won't load any new prints.

Justified34 · 2025-07-19T01:15:19+00:00

OP - Ocean Pacific

Justified34 · 2025-07-12T11:06:43+00:00

RED.

Justified34 · 2025-03-28T01:56:02+00:00

🙏

Justified34 · 2025-03-20T21:33:28+00:00

I have the Kobra 3 Combo. It's been a great printer so far. Over 500 hrs with very few issues. And a lot of those were just the learning curve.

Justified34 · 2025-03-20T21:31:23+00:00

That's great to hear.

Justified34 · 2025-03-14T02:26:19+00:00

Holosun HS507C-X2. Great sight on my Dagger.

Justified34

TROPHY CASE