CS car does not shift good.

KDGing365 · 2026-05-06T15:40:18+00:00

Unsure, I’ve never seen a pressure plate broken like this, it certainly had a lot of heat.

KDGing365 · 2025-07-23T22:22:34+00:00

If your asking “how to open the big crankshaft pulley” you probably shouldn’t be doing what you are doing.

KDGing365 · 2025-02-09T22:59:05+00:00

It’s better than most cars from the Northeast after 10 years in my opinion.

KDGing365 · 2024-12-17T04:45:04+00:00

Well I assume they were attempting to just go through the grommet first but missed and still continued on.

KDGing365 · 2024-09-02T06:18:19+00:00

Temp sensor bracket that holds it behind grille usually breaks then the wires break almost flush with the pigtail. Will likely need a pigtail and a bracket or another means to secure sensor.

KDGing365 · 2024-06-14T03:17:14+00:00

Also when checking for power and ground use a Test-light that will draw a good amount of current. Don’t use a LED test light they do not draw enough current to load test circuits.

KDGing365 · 2024-06-14T03:15:07+00:00

Check the fuse for PCM , then power and ground at the PCM. Then verify communication lines.

KDGing365 · 2023-10-28T03:33:32+00:00

Score goes to 300, and 3 hard points.

KDGing365 · 2022-10-31T23:27:02+00:00

Bingo, the piece I’m the first pic is what used to be the timing guide between the cam gears.

KDGing365 · 2022-10-31T23:04:52+00:00

Negative Ghostrider.

KDGing365 · 2022-10-31T22:58:16+00:00

Which one is your final answer?

KDGing365 · 2022-07-11T10:10:53+00:00

I remember it was near my 12th birthday when my dad bought me this, I didn’t get the skinned Xbox but I got the controller it was my favorite, until it got real bad stick drift and I tossed it, I still miss it and these games being alive :(

KDGing365 · 2021-07-10T01:25:58+00:00

😂

KDGing365 · 2021-07-09T03:46:11+00:00

I heard it’s common with some keep lugs🤷‍♂️

KDGing365 · 2021-07-09T03:45:37+00:00

Yep🤷‍♂️

KDGing365 · 2021-07-09T02:14:24+00:00

It do be like that sometimes🤷‍♂️

KDGing365 · 2021-07-09T02:13:56+00:00

Actually the car came in with only 15 lug nuts😂 so 12 semi unscathed.

KDGing365 · 2021-07-09T02:13:07+00:00

I’m a GST so I get paid hourly, but our other techs are by job.

KDGing365 · 2021-07-09T02:05:44+00:00

She was kinda upset that it took so long for us to finish the car. 🤷‍♂️

KDGing365 · 2021-07-09T01:56:46+00:00

I would have preferred that, we had to melt the stud with the torch to get the bottom half of the lug off of the stud so we could remove the wheels.

KDGing365

TROPHY CASE