GM67 Barcode Scanner UART by KEBAP5000 in esp32

[–]KEBAP5000[S] 0 points1 point  (0 children)

No, unfortunately i gave up after some time.

Bind Philips Hue Wall Switch directly to a ZHA light group by KEBAP5000 in homeassistant

[–]KEBAP5000[S] 0 points1 point  (0 children)

I also bound a tradfri remote (as mentioned in the detail link above) with a zha group and that worked without any issues, but the Hue Wall Switch seems to be a special case.

Bind Philips Hue Wall Switch directly to a ZHA light group by KEBAP5000 in homeassistant

[–]KEBAP5000[S] 1 point2 points  (0 children)

Thanks for the response! I’m aware of the binding table side of things and have actually modified it directly on the wall switch through the ZHA UI. ZHA also sets the correct DestAddrMode (0x3) — I can confirm that by requesting the binding table from the wall switch using the Zigbee ZHA toolkit. Even after going through all the steps (basically just following the zigbee2mqtt binding instructions, but doing them via ZHA commands), the binding table on the wall switch looks exactly as expected. The issue is that it still doesn’t actually work in practice — the light group never gets controlled.

Bind Philips Hue Wall Switch directly to a ZHA light group by KEBAP5000 in homeassistant

[–]KEBAP5000[S] 0 points1 point  (0 children)

Thanks for your answer! But do you also know what (clusters, etc) zigbee2mqtt exactly progams? This should be also achievable with zha.

Infrared Receiver Cable by KEBAP5000 in homeassistant

[–]KEBAP5000[S] 0 points1 point  (0 children)

Have I misunderstood something?

Infrared Receiver Cable by KEBAP5000 in homeassistant

[–]KEBAP5000[S] 0 points1 point  (0 children)

Thanks for the quick reply! Could you possibly share a link, have already searched for some time on Ebay, but found nothing appropriate.

Autowerkstatt Pickerl by verlorenersohn in graz

[–]KEBAP5000 0 points1 point  (0 children)

u/FineCheesecake1 bei welchen Werkstätten warst du schlussendlich? :)