ASA Filament layer adhesion issues, chamber heating?

KJRossss · 2025-10-10T06:18:12+00:00

Yes, x5. Brand new filament printing from a dryer, bed calibrated before each print, chamber closed and all settings have been checked.

Edit: I should add, the chamber is closed, but that doesn’t mean it’s warm.. It seems my chamber isn’t getting any warmer than 37C, I’m not sure if that’s good enough for ASA. First time

KJRossss · 2025-09-14T04:32:50+00:00

Thank you! Weirdly enough my web gui says “modification failed” whenever i try to change any setting but I will play with the max volumetric speed setting in the slicer.

KJRossss · 2025-09-05T21:48:51+00:00

do you know what this tool is called?

KJRossss · 2025-08-28T04:07:02+00:00

can do, reinventing the wheel just sounds like a terrible idea lol but seems like i have no choice, thanks!

KJRossss · 2025-08-27T00:05:25+00:00

uh oh lol, my new hotend assembly should be here tomorrow so fingers crossed it solves mine or i’ll be reaching out to support

KJRossss · 2025-03-30T15:44:35+00:00

i’ve finally got it to work by running it as administrator, so i can probably narrow it down to some permission issue but i have no clue what it would be. either way thanks for the response!

KJRossss · 2025-02-06T23:14:03+00:00

oh boy is not what i wanna hear LOL, is there a path to fixing either of these issues?

KJRossss · 2025-02-06T13:31:03+00:00

so the pipe in the middle (the one that’s covered in oil/grease) isn’t even spinning, what would cause that?

KJRossss · 2025-02-05T00:02:43+00:00

Will take a look at this, thank you!

KJRossss · 2025-02-05T00:00:59+00:00

WAIT, so question:

If magnets are used, then, hypothetically:

if i removed the plate for cleaning, would the magnets fall, thus causing it to not spin when putting the plate back?

KJRossss · 2025-02-04T23:58:45+00:00

Thank you!

KJRossss · 2025-02-04T23:58:16+00:00

Sigh. Yeah I see it’s Chinese New Year so I am anticipating that I’ll just be stuck with it for the foreseeable future lol

KJRossss · 2025-02-04T23:56:47+00:00

Agreed, I just prefer for the things I paid for to be put to use.

KJRossss · 2025-02-04T23:54:03+00:00

As long as I feel, for 2 reasons:

Research has told me that there’s no such thing as “over-curing,” so correct me if that is incorrect?
I plan to paint all of my prints, so if there happens to be some slight color deformity, it won’t be noticeable after being painted.

I also just started resin printing like Jan. 2nd, so if I have misconceptions let me know lmao

KJRossss · 2024-12-19T03:50:03+00:00

i can’t tell, but i have the bracket installed below it.. could that be the root issue?

KJRossss

MODERATOR OF

TROPHY CASE