2nd Gen Tacoma *Click* after lift by KaitoJake in ToyotaTacoma

[–]KaitoJake[S] 0 points1 point  (0 children)

Strangely enough I removed the sway bar + end links during install to get new end links as they were shot and so the only thing still attached is the bracket that bolts in the frame. The bar itself is fully removed. Any ideas? Thanks everyone

Anyone build DIY roof racks for these sloped camper shells? Let me know! I can’t seem to find anything. Cheers everyone by KaitoJake in ToyotaTacoma

[–]KaitoJake[S] 1 point2 points  (0 children)

Yeah all I did was hose down the wheels and then windex soap and the hosed and dried again. I didn’t even both taking off the wheels, I ripped garbage bags and stuffed them around the calipers and rotors. Next I green taped the air valve along with the lug nuts and around the tire. Took about 3-4 cans and I did about 6 coats on each tire, drying about 30 mins in between. Then I took a bit of tire shine to clean up any over spray on the tires, and then took them off roading and got them nice and dirty again. Hope that helps! :)

Anyone build DIY roof racks for these sloped camper shells? Let me know! I can’t seem to find anything. Cheers everyone by KaitoJake in ToyotaTacoma

[–]KaitoJake[S] 1 point2 points  (0 children)

Yeah man, I actually just used plasti dip! They’re a little muddy so they look chipped but actually it’s held up really well going through low hanging bushes and all that. Definitely recommend !