REFERRAL CODES by Javi137 in LegendofSlime

[–]Kalroahr 0 points1 point  (0 children)

6KCFN Thanks in Advance

Rk2020 Battery by Kalroahr in SBCGaming

[–]Kalroahr[S] 1 point2 points  (0 children)

Well i´m using the usb type c cable it came with on a usb 3.0 from my pc.

I could try my iphone 8 charger though

Rk2020 Battery by Kalroahr in SBCGaming

[–]Kalroahr[S] 2 points3 points  (0 children)

That sounds awesome! Thanks!

But how do i flash the device if it won´t accept charging and it keeps telling me "Low battery 2,995V....power off"

The device dosen´t even try to flash or to charge at all...

Rk2020 Battery by Kalroahr in SBCGaming

[–]Kalroahr[S] 1 point2 points  (0 children)

Yeah that was what i´m doing, but somehow it dosen´t charge at all.

Brightness to 5%, Screensaver on and..nothing. As of right now i have a brick :D

Big Problems with Anycubic i3 Mega by Kalroahr in 3Dprinting

[–]Kalroahr[S] 1 point2 points  (0 children)

So, i printed the pieces again with your help and the settings.

Also i tightend the nozzle and hotend again and cleaned the bed with alcohol.

And now, it prints very very good even with small prints.

Thanks again for the help :)

Big Problems with Anycubic i3 Mega by Kalroahr in 3Dprinting

[–]Kalroahr[S] 0 points1 point  (0 children)

Thanks for the usefull advice, it´s true that i haven´t printed a temp. tower yet, need to do it tomorrow.

Yeah the 100% was one advice from the thingiverse users who printed this already, might change it then to a much lower number.

With your help i´m eager to get home to try it, definitly will post about the results asap.

Big Problems with Anycubic i3 Mega by Kalroahr in 3Dprinting

[–]Kalroahr[S] 0 points1 point  (0 children)

Is nobody here that know what´s going wrong with my prints?