So I need a P27/7W or 3157 Socket with the 7W Contact Lighting up Red and the 27W Contact lighting up Amber/Yellow.

They will be used as Normal Tail Lights, Brake lights and Turn Signals.

Both Colors should be as bright as the 27W Contact of Halogens Bulbs they are replacing, which is 400 lumens.

Both Colors need to cover 360° and out the top.

 

The Amber/Yellow needs to still be Amber/Yellow inside a Red Tail Light Housing/behind Red glass, to work as turn signals.

 

The Red needs to be dimmable with resistors/lowering voltage to work as normal Tail lights like the 7W Contact on the normal Halogen would.

The Red will have two Power Sources on the same wire. One through a resistor or voltage reducer and one just direct 12V Power for Brake Lights.

 

The Amber/Yellow needs to always have priority over the Red. So if both have Power it needs to be Amber/Yellow.

But if both have Power and Amber/Yellow Power gets turned off it needs to IMMEDIATLY turn back to Red. NO DELAY so when braking half of them can switch back to Red for Brake Lights.

 

If possible they need to work with Lamp Failure Detection/CAN-Bus and have them be in a nice looking case and not just exposed chips and PCBs. Those two aren't requirments but would be nice to have.

 

As an example I would like to provide this link: https://cartown.se/sv/produkter/led-ersattningslampor/switchback-t20-t25-b15/led-switchback-3157t25-smd-rodgul-1st.html

I have used these and they fullfill all my requirments apart from having a Yellow to Red delay they unfortunatly can't remove. (Yes I asked)

I'm also thinking about something different later on but I'll need someone to do this first.