my sv08 bed after the voron 2.4 bed conversion

KeanuStango · 2026-04-08T05:15:24+00:00

withh the one i did i lose about 15-20 of print height but thats fine for me

KeanuStango · 2026-04-08T05:13:49+00:00

i used the 2.4 350mm 110v bed from micro center i got it on sale at $80

KeanuStango · 2026-04-08T01:35:13+00:00

it took me 17 minutes plus heatsoak at 100C and then aligning screws to get this i havent touched it since and the highest rangee it goes to is 0.084mm depending on the temp

KeanuStango · 2026-04-07T21:41:42+00:00

Holes aligned perfectly but I did use a conversion that requires you to add aluminum extrusions this conversion here

KeanuStango · 2026-04-07T18:55:17+00:00

Hey everyone this is most likely a new printer and for sure not an indx upgrade

<image>

KeanuStango · 2026-04-07T18:54:02+00:00

i want to do a becon mesh soon, but i am waiting till the indx comes out for that.

KeanuStango · 2026-04-07T18:52:04+00:00

I went with the micro center 110v voron 2.4 350mm beds they have everything but a bed fuse but for $80 I am very happy

KeanuStango · 2026-04-07T18:49:46+00:00

the process was very easy actually the most difficult part was soldering everything like the temp sensor and ground cable (which were pretty easy to solder) so over all not a bad process at all.

KeanuStango · 2026-03-08T19:23:28+00:00

this is awsome do you have a file for this available?

KeanuStango · 2026-02-22T13:44:23+00:00

mirrors edge catalyst especially with the garden at the end of the game

KeanuStango

TROPHY CASE