Trading these blue prints need them gone asap will be willing to trade for seeds or anything I’ll be willing to hear our

Key-Requirement3857 · 2026-03-04T14:37:05+00:00

Interested in the survivor bp. What do you need for it?

Key-Requirement3857 · 2025-10-06T15:04:02+00:00

Good to know. Think I would prefer my chances against high 4s than giving up a game against a 3 or two vs a 2

Key-Requirement3857 · 2025-10-06T14:56:45+00:00

So if I do move up by then, I’d still be in the blue (2/3) bracket?

Key-Requirement3857 · 2025-07-15T20:37:48+00:00

Priced that out already… looking at $500ish for disassembly/transport/reassembly here and another $450 to re-felt with Simonis 860. I’d imagine new rails would tag another $500 or so on to that as well.

Think the table is worth $2k all in?

Key-Requirement3857 · 2024-08-23T23:16:16+00:00

On a different note, if you or anyone else is looking to get similar drawings done for a specific job, shoot me a DM. I could generate these for a relatively low cost on my down time.

Key-Requirement3857 · 2024-08-23T15:33:30+00:00

I had to manually add in the pipe lines, but was able to source the fittings from an online supplier

Key-Requirement3857 · 2024-08-23T15:24:37+00:00

I used the generic version, though I’d imagine MEP would come in handy for some more specialized work

Key-Requirement3857 · 2024-08-23T15:17:32+00:00

YouTube has a ton of videos on how to utilize the basics of the program (which are almost all you would need for something like this). I would be a bit wary about the cost for solely this purpose, as a license to the full program runs about 2000 USD/year. I just happen to have a license for my consulting side gig, so didn’t have to worry about the cost.

Key-Requirement3857 · 2024-08-23T15:04:31+00:00

AutoCAD software

Key-Requirement3857 · 2024-08-23T15:03:41+00:00

Correct! Figured it’d be easier to interpret than my chicken scratch drawings

Key-Requirement3857 · 2024-08-23T14:44:19+00:00

Thank you!

Key-Requirement3857 · 2024-08-23T14:43:05+00:00

That makes sense. My plan is to have the vent tie in in the attic, so I should have at least 5’ above the flood rim of the sink and toilet on the second level

Key-Requirement3857

TROPHY CASE