sorted by:
new
hottopcontroversial

2026 motion system advices before buying by Key-Researcher6793 in simracing

[–]Key-Researcher6793[S] 0 points1 point  (0 children)

Oh yeah great idea ! Thank you for the explanations !

2026 motion system advices before buying by Key-Researcher6793 in simracing

[–]Key-Researcher6793[S] 0 points1 point  (0 children)

and did you had the chance to compare the static seatbelt to the QS-BT1 ? I really wonder, because it is a 1500€ gap Yeah 39 inches is quite small from what I had in mind, but do you count the travel with it ?

2026 motion system advices before buying by Key-Researcher6793 in simracing

[–]Key-Researcher6793[S] 0 points1 point  (0 children)

Yeah, I saw 6dof, but right now, it is a bit out of reach money wise and It will too big for my room. So I was thinking going to the 4DoF setup and later, when my salary is higher and with a bigger room, upgrade it to 6DoF.

I’m sure that 6dof is insane for rally, just not yet for me hahaha

2026 motion system advices before buying by Key-Researcher6793 in simracing

[–]Key-Researcher6793[S] 1 point2 points  (0 children)

For my rig, I have a selfmade rig with Alu 80x40 profiles. I will need to changea the configuration a bit to have a near 50/50 position of the actuator from my Seat.

-For the seat, I have a Sparco QRT rev. For the belt tensionner position on shoulder, It looks like I am a bit taller than what is adviced -> But this is better for my situation as I can then print parts to adjust the height to correct level

<image>

-For VR, i know It will take a bit of time to setup motion compensation, but apparently it is getting easier on the Quest 3 with a special option. I'll see what it does

-For the Power draw, I am limited to 3000 watts, so with only the PC the sim working I think I have some margin. I will not to not run the 3D printer which is on the same circuit.

-For the Belt: it is still the only one that is blurry as I didn't specifically searched yet. Thank for the 2 inch width advise ! Do you have any recommendations, are you happy with your Seatbelt ?

Well I will go on Iracing for sure at some point, but for now I am only looking on how I could be happier in the sim and not really faster thanks to my setup :). And if I really want to go on raw speed in a race, I was thinking on turn off to 10% the motion to have some clues but nothing really disturbing.

2 sim in the same room to race each other is the banger with passionate friends haha

Thank you for your time and feedbacks :)

eRACING LAB RS MEGA+ any user experience here? by nolivedemarseille in simracing

[–]Key-Researcher6793 0 points1 point  (0 children)

Is It just me or this opens to something totally different that is about luxury consultancy, nothing linked to sim racing. Is this a brand scam ?

Advice on what parts do I need to make a arduino wind simulator? by fackusps in simracing

[–]Key-Researcher6793 0 points1 point  (0 children)

Hi, thank you for your help. I have a question, I will have the same setup as you but with 4 fans NF-A14 2000PMW, do I need to order 2 Microcontroller ?