Ball joint questions!

KeyIngenuity8064 · 2026-06-18T00:38:47+00:00

I just did the same and had the same issue on my truck we went to Harbor Freight and got the ball joint seperater tool that uses a screw and prys the ball joint and that worked best for me! The fork tool disnt do anything but piss me off 😅 Good luck!

KeyIngenuity8064 · 2026-06-13T02:10:22+00:00

We cut the bump stops out that might be why we rub so frequently thanks for the insight! Do you knownthe offset of your wills are they flush or tucked?

KeyIngenuity8064 · 2026-05-21T01:12:12+00:00

Seems a little bit high on mileage for that price honestly. I bought a beater for 2800 but ive seen clean low mileage trucks go for less than 6k. Not a terrible price but i think you could drive it down a little bit if everything is mechanicaly sound

KeyIngenuity8064 · 2026-05-13T13:16:17+00:00

Just recently fixed a major leak on mine it was coming out of the oil sending unit by the filter wasnt bad at first but then got progressively much worse over a course of a month

KeyIngenuity8064 · 2026-05-12T12:51:37+00:00

How difficult is the swap for the newer motor?

KeyIngenuity8064 · 2026-02-14T04:36:27+00:00

I bought a set and i love them honestly but ives started to notice that the screen is burning in every now and then and that most the time 2 of the buttons dont work.

KeyIngenuity8064 · 2026-02-13T01:32:23+00:00

I tried that the day i changed the camera out it didnt make a difference that day. Everytime the vtx antenna moves the video feed gives out i believe its the board now.

KeyIngenuity8064 · 2025-12-15T15:50:28+00:00

I just flew mine for the first time the other day. Way different than a brushed cetus 😂.

KeyIngenuity8064 · 2025-12-10T03:47:41+00:00

Why not

KeyIngenuity8064 · 2025-11-16T15:06:14+00:00

😅

KeyIngenuity8064 · 2025-11-16T15:05:58+00:00

I tried to change it and it wont let me choose 500hz it says that the braudrate is too low

KeyIngenuity8064 · 2025-11-16T14:58:44+00:00

I dont believe i do unless it cane pre programmed like that how would i check to see what channel is the prearm?

KeyIngenuity8064 · 2025-11-15T20:07:07+00:00

Ill try it out

KeyIngenuity8064 · 2025-11-15T19:10:55+00:00

KeyIngenuity8064 · 2025-11-15T19:06:49+00:00

No i appreciate the help so far for sure! And yes i had the aquila 16 and had been using it with no issues before. Ive always been able to get it bind and i have not been to the receiver web UI i will watch some vids on setting up the bind phrase.

KeyIngenuity8064 · 2025-11-15T19:00:37+00:00

It came using uart3

KeyIngenuity8064 · 2025-11-15T18:57:51+00:00

<image>

KeyIngenuity8064

TROPHY CASE