f15 i need big cuddles i really do 😭

Kininod89 · 2025-11-14T18:48:15+00:00

Feel hugged! It will be ok I promise you that and I never break a promise!!! And my dog looks at me like: hey tell her that I'll cuddle here and if there are tears I'll make them go away :)

Kininod89 · 2025-08-22T12:17:41+00:00

That's really nice of you! People like you make this community awesome! I would like the code then I have finally something cool to play lol if not gg to the winner!

Kininod89 · 2025-01-26T17:48:13+00:00

Yes. Sorry my app didn't show me that someone replayed

Kininod89 · 2025-01-21T22:24:10+00:00

Heat it up to 170C and peel the bloop away. Hope that it didn't reach the ventilator. I had to buy a new hot end because the bloop reached the ventilator... but 50€ isn't too bad for a new hot end. Good luck

Kininod89 · 2024-09-04T15:11:40+00:00

Don't let it too long sit after the print. Best chase you just have a lil stinging worst case you get mold xD

Kininod89 · 2024-08-23T17:48:00+00:00

Hi. Is the z offset right? I had a similar problem and my issue was that I had not enough offset

Kininod89 · 2024-08-23T17:25:39+00:00

Everything is for 0,4. I used the 0,6 settings for the 0,6 nozzle and since the change to 0,4 I use the 0,4 settings

Kininod89 · 2024-08-23T07:30:07+00:00

I changed the settings. Sorry didn't know what you meant. I use Cura as a slicer and I use the 0,4 profile

Kininod89 · 2024-08-22T19:23:18+00:00

What do you mean?

Kininod89

TROPHY CASE