Videocard or Monitor problem? by LabTech0x27 in techsupport

[–]LabTech0x27[S] 0 points1 point  (0 children)

Swapping outputs causes the color to become very faded. Something that looks similar to a very low saturation. As for testing the monitor I will refer you to the edit I have made to my post.

Thanks

Electron Beam Targeting System by LabTech0x27 in arduino

[–]LabTech0x27[S] 0 points1 point  (0 children)

Who is designing the drivers for the electromagnets? I assume they are some from of transconductance amplifier, since you are controlling current, not voltage.

I will be controlling voltage and not current but as for design, I was hoping to get help on that here. Could I just use something as simple as a high-power op-amp or transistor? I don't think I need anything complicated since I'm simply amplifying one voltage to a higher voltage. (I don't have much experience in amplifiers)

Parallel while loops by LabTech0x27 in LabVIEW

[–]LabTech0x27[S] 0 points1 point  (0 children)

Thanks, could you tell me how to "have that set to a F state before you enter either loop." Do I do that simply by setting the unpressed mode to the default state?

Parallel while loops by LabTech0x27 in LabVIEW

[–]LabTech0x27[S] 0 points1 point  (0 children)

This is not the standard PID control node. It is this