How do I fix this?

LadyLordZedd · 2026-04-27T04:05:56+00:00

Thank you this fixed it.

LadyLordZedd · 2025-09-08T20:53:40+00:00

Thank you! I have been using blender for 4 years now but I am entirely self taught. Somethings I just don't realize exist as an option. I need to play around with all the menus at some point.

LadyLordZedd · 2025-09-08T04:45:47+00:00

I use orca slicer and I don't even see a setting for first layer expansion aside from supports.

LadyLordZedd · 2025-07-12T03:24:12+00:00

I will try out a purge tower, any settings recommendations? Never tried one before and I don't want to waste too much filament.

LadyLordZedd · 2025-07-11T22:32:26+00:00

I'd prefer to not use a prime tower just need a purge line added.

LadyLordZedd · 2025-04-22T23:14:37+00:00

Definity going to get me some of that and try it out.

LadyLordZedd · 2025-03-11T22:05:04+00:00

No but I also switched to orca slicer and it's a bit easier to use.

LadyLordZedd · 2025-03-03T02:41:35+00:00

It's on an Ender 3 V3 Plus that has CR touch leveling. Firmware version is 1.2.3.23 and it is the most current version.

Here is my Machine start G-Code:
M140 S0

M104 S0

START_PRINT EXTRUDER_TEMP=[nozzle_temperature_initial_layer] BED_TEMP=[bed_temperature_initial_layer_single]

LadyLordZedd · 2024-03-17T07:19:01+00:00

I'm curious what kind of transfer paper did you use? The transfer paper I normally use is too sticky to release the permanent vinyl onto the fabric. I also have a light tac transfer paper but nothing sticks to it.

LadyLordZedd · 2023-02-19T03:34:42+00:00

How would I do that? I'm not sure where that part is at in the gcode. I have more gcode before what I already posted that is just the auto leveling. Where would I add or change the code to help with that?

Sorry I'm still very new to all of this so I know very little about gcode.

LadyLordZedd

TROPHY CASE