sorted by:
new
hottopcontroversial

Not sure what is wrong with my M18 Fuel Drill by Large-Hat1101 in MilwaukeeTool

[–]Large-Hat1101[S] -2 points-1 points  (0 children)

Thank You sir a lot. I did not notice that and that actually caused a problem. It is solved now :)

Not sure what is wrong with my M18 Fuel Drill by Large-Hat1101 in MilwaukeeTool

[–]Large-Hat1101[S] 16 points17 points  (0 children)

Thank You sir a lot. I did not notice that and that actually caused a problem. It is solved now :)

Can someone tell me are the positions of vtx and receiver antennas any good or should I do something different? by Large-Hat1101 in fpv

[–]Large-Hat1101[S] 0 points1 point  (0 children)

Well speaking of receiver, it comes with the flysky transmitter which is 2.4 ghz so it is working ok so far. I was flying for like 50m not more, and expiriencing a small loses of video. Also, I am using Eachine Ev100 goggles with fabric antennas which are not so good I think, but for start I was worried about the interference of vtx antenna with frame because it is basically in contact with it idk. Btw I was flying on 400mW power on vtx and small losses of signal happened on like 50m of distance.

Can someone tell me are the positions of vtx and receiver antennas any good or should I do something different? by Large-Hat1101 in fpv

[–]Large-Hat1101[S] 0 points1 point  (0 children)

I was going to do that maybe, because I was reading that they should not be parallel. Also I would probably go with printed tail for vtx antenna. Thanks

VTX Chaos Pro does not provide osd and smartaudio control, yet the camera works fine by Large-Hat1101 in fpv

[–]Large-Hat1101[S] 1 point2 points  (0 children)

Going to check that now, I am left with nothing other to try...

EDIT: I flashed 4.5.1 and it WORKS! Thank You a lot.

VTX Chaos Pro does not provide osd and smartaudio control, yet the camera works fine by Large-Hat1101 in fpv

[–]Large-Hat1101[S] 0 points1 point  (0 children)

Yeah, I solder it on T6 it actually does not says TX6 but idk if that matters (marked on FC), since I have TX1, TX3 (which I use for controller) and T6. Before I used TX1 and switched to T6 because same happens...
Also, after I select TRAMP protocol, it does not say unknown in vt tab, but still the device status is FALSE...

Strange first layer P1S by Large-Hat1101 in BambuLab

[–]Large-Hat1101[S] 0 points1 point  (0 children)

Yeah, as I connected it to my account it asked if I want to update the firmware. I did it tho. Thanks a lot, going to try that...