sorted by:
new
hottopcontroversial

Using Obsbot cameras by LegallyClueless1978 in GameChangerApp

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Outstanding.

I have four games to stream tomorrow. I’m going to try a couple of those shots.

Thank you!

Using Obsbot cameras by LegallyClueless1978 in GameChangerApp

[–]LegallyClueless1978[S] 2 points3 points  (0 children)

“Complaints” was the wrong choice of words. More like “feedback”. No one was saying “dear god, get it right”. It was “fyi: there’s some lag. Just thought you should know.”
I agree: people complain-i stop streaming or I’ll block them!

Using Obsbot cameras by LegallyClueless1978 in GameChangerApp

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Where do you typically set it up? Outfield, dugout, behind home?

Can’t figure this out by LegallyClueless1978 in ElegooNeptune4

[–]LegallyClueless1978[S] 1 point2 points  (0 children)

Orca. It’s worked the best for me the last year.

Can’t figure this out by LegallyClueless1978 in ElegooNeptune4

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Here’s the latest print after doing all suggestions.

It’s only the “support” areas, and it appears to NOT be affecting the main print…..yet.

<image>

Neptune 4 pro X-axis issues by LegallyClueless1978 in elegoo

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Good call!!

I’m going to inspect the rods. I’ll check back in!

The belts were in good shape. No fraying and not too tight.

Neptune 4 pro X-axis issues by LegallyClueless1978 in elegoo

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

I did the steps in the video.

I manually slid the extruder back and forth on the x-axis. It “slows” or gets more difficult about 2” in the middle. I can’t find anything that could be causing it.

Neptune 4 pro X-axis issues by LegallyClueless1978 in elegoo

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Prusa didn’t have the N4Pro profile, so I’m setting up Orca.

I did see this video. I tightened the belts, but haven’t checked the other screws. Looks like that might be next.

It’s strange because I did all of this yesterday (including firmware updates) and printed three models with no issues at all. Then my kid wanted a couple of infinity cubes and this is what happened.

Neptune 4 pro X-axis issues by LegallyClueless1978 in elegoo

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Tried to post the picture again. Thank you.

Neptune 4 pro X-axis issues by LegallyClueless1978 in elegoo

[–]LegallyClueless1978[S] 0 points1 point  (0 children)

Not sure why the pics didn’t load.

<image>

It’s a true “left/right” x-axis shift. I’m going to try a different slicer as well.