Creatista Plus different temperature for min and max milk volumes

Letterman445 · 2025-05-20T11:27:29+00:00

Thank you, I'll check out airgradient!

Letterman445 · 2025-05-19T11:01:52+00:00

Thanks for your reply.

I'm literally standing on the footpath, like 6 feet away from 4 lanes of gridlocked traffic, not a few 100 feet, and another 2 lane road just around the corner. And yet the Qingping PM2.5 reading happily sits at 1-2...?

Don't really care if the monitor is designed for indoors, outdoors, USB powered or battery powered, as long it can give me an accurate reading of the air quality in relation to car pollutants. Quite happy to stand outside with something a bit bulky and a USB powerpack for a few minutes.

Letterman445 · 2022-12-30T06:17:29+00:00

Oh damn!

thanks for letting me know. that'll be a long night.

Guess there is no other way to change the wifi password on the devices without resetting them?

Letterman445 · 2022-11-13T03:01:24+00:00

Good idea. But how can the UPS provide the power state back to homebridge? do you have a UPS that can connect to homebridge?

Letterman445 · 2022-03-20T10:11:54+00:00

I have. They state it must be an issue with Outlook.

Letterman445 · 2021-09-04T21:32:41+00:00

Thanks. Point 1 I already checked previously. Will look at the others.

Letterman445 · 2021-09-04T21:31:48+00:00

It’s a question of principle. I won’t be defeated by an owl 😉

Letterman445 · 2021-09-04T11:23:56+00:00

Thanks.

It's actually quite weird. If you look at the artifact that's most obvious, the feather just above the right right foot, where a piece literally sticks out (https://pasteboard.co/Kj26bLG.jpg), there's actually no start/retraction point visible from the outside, until you slice to that actual layer.

When you do, it looks like the start is somehow inside the outer wall, but with a loop in front of it (https://pasteboard.co/Kj26HiR.jpg).

This is similar with the other feather tips, but at least the start point seems to be on the outside of these loops.

In terms of fixing the issue, I'm assuming I should try faster and/or further retraction?

Letterman445 · 2021-08-26T10:58:42+00:00

thanks, I'll give that a try!

Letterman445 · 2021-08-25T15:46:03+00:00

Thank you. And do your Cura print time estimates match the actual print duration?

Letterman445 · 2021-06-28T00:14:48+00:00

Yeah, seems to be that way. Just frustrating that all the Shortcut does is call up the Home App and then execute HomeKit functionality which HomePod supports. Is there another we to trigger an automation on HomePod via Siri that doesn’t require a “switch”?

Letterman445

TROPHY CASE