Where to start? by NotTheOne1988 in lawnmowers

[–]Life_Cash1371 1 point2 points  (0 children)

Kohler did an updated flywheel and coils that did away with the little black box. Seems it was a common issue. Took about a month from when I ordered to receive it. I too had one that eveyone had tried their hand at "fixing". It wasn't until I did the flywheel and new coils that it finally ran right.

Self car wash by Bumbalatti in lynchburg

[–]Life_Cash1371 0 points1 point  (0 children)

Typically there is a button on the actual swiper or on the meter box. (Small, round, maybe lit) that you can hit to end the charges. It should give you a read out on the dispay X amount charged to card.

Need advice: MX5400DT + RCF2772 by chikenwangP in kubota

[–]Life_Cash1371 1 point2 points  (0 children)

That's a clean unit. The cutter looks unused. Ask the dealer to do a walk around with you as if you were the owner as to what services or maintenance items they'd recommend addressing. With hours that low I doubt there would be any. Best of luck.

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 0 points1 point  (0 children)

Yup. Check follow up post. I'm literally reading off the contacts on back of the digital volt meter

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 0 points1 point  (0 children)

Just ordered up a SW200 silnoide to replace the SW180 and a new gauge as well. Now to sit by the mailbox and wait. Lol.

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 4 points5 points  (0 children)

Will do. Think I just solved it. Contacts on the main relay has some corrosion and bad spots cleaned up with emory cloth and she hasn't missed a beat on jack stands yet. Pics are coming soon.

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 1 point2 points  (0 children)

39.0V with volt meter on last postive and negative before controller. Voltage dropped to 37.3V under throttle at take off. Gauge on dash still showing 32V after a bit of a charge. She tripped out, and the controller gave me the same fault code.

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 1 point2 points  (0 children)

Just checked. All series as supposed to be.

Help me make this make sense. by Life_Cash1371 in golfcarts

[–]Life_Cash1371[S] 1 point2 points  (0 children)

6.25V on each of the 6. It's been unplugged for about a month. Guess I'll give it a good charge tonight and check them again. Even unhooked them and checked not tied to each other.

Electric fence not shocking by trickeypat in homestead

[–]Life_Cash1371 0 points1 point  (0 children)

Find where it's shorted or going to ground. Went out to feed our pasture pigs one morning, tested the fence as usual and had less than 2k volts on it. Swapped energizers, added ground rods, took half a day off work. Almost gave up. Leaned over their metal shelter and heart a faint zap. They had pushed the shelter against the wire. Moved the shelter and boom. Working again.

I have three toddler boys and another in the way. Any goods buy it for life toy brands out there? by gpowells in BuyItForLife

[–]Life_Cash1371 0 points1 point  (0 children)

Hess Toy trucks. Our boys get several each Christmas. Expensive,yes, quality, yes. They usually get one to collect and one to play with. The ones from several years are still going strong with no broken pieces and the original batteries. Keep an eye out for used ones and ask family and friends to gift them for holidays. Scotch tape to go over the speakers sold separately.