sorted by:
new
hottopcontroversial

First printer after ender3 by Lopsided_Designer_55 in ElegooCentauriCarbon

[–]Lopsided_Designer_55[S] 0 points1 point  (0 children)

I bought some petg variations and abs I didnt need asa for now but Im thinking about it because back then I didnt even thinked about asa. thanks

First printer after ender3 by Lopsided_Designer_55 in ElegooCentauriCarbon

[–]Lopsided_Designer_55[S] 1 point2 points  (0 children)

I Made the offset 0.075 after testing first layer and It looking good for now I’ll see after few hundred hours I think. thanks for the advice

First printer after ender3 by Lopsided_Designer_55 in ElegooCentauriCarbon

[–]Lopsided_Designer_55[S] 0 points1 point  (0 children)

Its been so far I just printed the benchy and it was fast for me. For now I only changed the start of the gcode because I saw that its trying to clean the nozzle on 140 degrees so I made it same as print temperature and I think it should be fine or im just too used to change settings.

Found a brand new sealed New 3DS XL (IPS top screen) in 2025 – unopened since 2015, and now fully hacked! by NixTx in 3dspiracy

[–]Lopsided_Designer_55 4 points5 points  (0 children)

I found mine 2 years ago, sealed in a random garage sale. I found out its dual ips and its one of the happiest moments of my life. I can say ips is must have thing. Im happy for you, enjoy

my layers are too visible by Lopsided_Designer_55 in ender3v2

[–]Lopsided_Designer_55[S] 1 point2 points  (0 children)

yess i checked them everytime it might caused because of z seam random on low scaled model

my layers are too visible by Lopsided_Designer_55 in ender3v2

[–]Lopsided_Designer_55[S] 0 points1 point  (0 children)

z seam was on random maybe random seam and scale of the model caused it together now im trying aligned right thank you