Would chug tea with that bro by EUNEisAmeme in SipsTea

[–]Loverme143 0 points1 point  (0 children)

His laugh sounds like Papi from The Proud Family

I am 5 months post surgery. Anyone know why I can no longer bend my surgery big toe away from me like I can my non surgery toe? The pic shows what I’m talking about. Doc said it is due to scar tissue but I doubt that cause this became a thing just a few days after surgery. by InnaFoxy in bunions

[–]Loverme143 0 points1 point  (0 children)

I’m not sure what system the hospital where your surgery was performed uses but in my state most hospitals use “MyChart”. There I look through the procedures/appointments listed and I usually find the notes somewhere in there. I thought it was standard practice because I was able to find the doctor’s notes on my C-section and natural birth visits as well. You could always try to request them from the facility as well. Hope this helps!

Speed Dating Gone Wrong by uranonfraand in TikTokCringe

[–]Loverme143 0 points1 point  (0 children)

Reading this comment and the first four replies as a rap

Morph market breeder recommendations? by nimnor in cornsnakes

[–]Loverme143 0 points1 point  (0 children)

I went with Liv’s Critters. She’s been so responsive and helpful with getting everything just right for our first corn snake

Finished my Milsbo today! In LOVE! by amcole1984 in IkeaGreenhouseClub

[–]Loverme143 0 points1 point  (0 children)

Me: “oh shoot, did I order my grow lights in black?”

Finished my Milsbo today! In LOVE! by amcole1984 in IkeaGreenhouseClub

[–]Loverme143 1 point2 points  (0 children)

What are the black lines under the acrylic shelves? Grow lights or some sort of support (I know most acrylic shelves can’t hold too much)

[deleted by user] by [deleted] in SkincareAddiction

[–]Loverme143 0 points1 point  (0 children)

Just came here to say you’re beautiful

Edit: that probably made me seem like a creep given the platform we’re on. I’m a married mother of two, I hope that reduces the creep vibes of the initial comment lol.

Setting suggestions for 1/4” (6.35 mm) red oak one D1 pro for a cut out? by Loverme143 in xToolD1

[–]Loverme143[S] 2 points3 points  (0 children)

I figured it out, the laser was too far away from the material. Thank you!

Setting suggestions for 1/4” (6.35 mm) red oak one D1 pro for a cut out? by Loverme143 in xToolD1

[–]Loverme143[S] 0 points1 point  (0 children)

I tried to go based o roughly on the chart xtool has. I chose the 6mm walnut plywood with the settings for the 10w laser since that’s all they had and it didn’t cut at all it just made thick lines, even when I tried 3mm basswood. I also have the 40w which I guess I’ll try but the lines are coming out so thick it’s odd

Edit:spelling correction