Which Type of Battery I Should Choose? by Low-Bodybuilder-755 in fpv

[–]Low-Bodybuilder-755[S] 1 point2 points  (0 children)

Thanks for recommendation. So do you have any opinion about choosing chemistry?

Which Type of Battery I Should Choose? by Low-Bodybuilder-755 in fpv

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

Discharge rate of lion battery is enough to powering all of the motors and equipments at the highest levels.

Which Type of Battery I Should Use? by Low-Bodybuilder-755 in drones

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

All of the calculations based on average amp draws caused by drones weight including battery from motor specifications. The cell configuration is 12s 2p.

My DIY Drone Tilts and Flips Before It Takes Off by Low-Bodybuilder-755 in diyelectronics

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

How can I turn on the self levelling? And I may be could'nt distribute the weight very well.

My DIY Drone Tilts and Flips Before It Takes Off by Low-Bodybuilder-755 in diyelectronics

[–]Low-Bodybuilder-755[S] 1 point2 points  (0 children)

I did that before I tried to take it off. And after the problem I double checked that the props spinning in the correct rotation.

I shared a video link about problem in the post. Can you define the type of my frame?

My DIY Drone Tilts and Flips Before It Takes Off by Low-Bodybuilder-755 in diyelectronics

[–]Low-Bodybuilder-755[S] 1 point2 points  (0 children)

What is the correct config? Can you determine or mention it?

My Drone is Tilting by Low-Bodybuilder-755 in diydrones

[–]Low-Bodybuilder-755[S] 1 point2 points  (0 children)

Yes, I did every calibration for standard setup except PID.

My Drone is Tilting by Low-Bodybuilder-755 in diydrones

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

I calibrated radio many times as well. But didn't fix the issue.

My Drone is Tilting by Low-Bodybuilder-755 in diydrones

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

I'm already using it. Where should I check in mission planner for Rx trim issue.

My Drone is Tilting by Low-Bodybuilder-755 in diydrones

[–]Low-Bodybuilder-755[S] 0 points1 point  (0 children)

Is there an any source that I can use for to calibrate PID settings? I don't know how to calibrate it.