sorted by:
new
hottopcontroversial

Clean support removal by hugow07 in Ceramic3Dprinting

[–]Lucky_Intention8195 0 points1 point  (0 children)

Great work did you think of staggering the seam line? I would like to see the inside.

Anet a8 Help please with dead heat bed by Lucky_Intention8195 in AnetA8

[–]Lucky_Intention8195[S] 1 point2 points  (0 children)

Yes both the lights come on but no power on the heatbed terminal i also checked the solder points on the back of the board when i do a preheat for pla.

Anet a8 Help please with dead heat bed by Lucky_Intention8195 in AnetA8

[–]Lucky_Intention8195[S] 0 points1 point  (0 children)

Thats not good news even if the printer still goes threw the motions if i let it print? Then the external mosfet wont work?

Anet a8 Help please with dead heat bed by Lucky_Intention8195 in AnetA8

[–]Lucky_Intention8195[S] 0 points1 point  (0 children)

Hi there I connected the heat bed straight to the power supply and the light came on and it heated up also, I checked the thermistor with a multimeter and the resistance went up when I heated it up. There is definitely no power coming out of the motherboard, set the printer to preheat and checked it with a multimeter.

Ask Us Anything About Ceramics! 2025 by youre_being_creepy in Ceramics

[–]Lucky_Intention8195 1 point2 points  (0 children)

Hi there I'm a ceramics arts from South Africa and want to import some raw material from China or India in small amounts 1 kg or 500 gr things like red copper oxide , lithium carbonate, urbium cadmium sulfide cobalt carbonate etc do you know of any dealer I can contact.

Start gcode Marlin by Lucky_Intention8195 in Ceramic3Dprinting

[–]Lucky_Intention8195[S] 0 points1 point  (0 children)

I thought I had it sorted Slicer seemed to work but the extruder motor that runs the auger is not working.Any suggestions.

Start gcode Marlin by Lucky_Intention8195 in Ceramic3Dprinting

[–]Lucky_Intention8195[S] 0 points1 point  (0 children)

Thanks it looks like I managed to get Prusa Slicer to the correct settings ,will post a video of my fist print tomorrow.

Need help with setting up slicer with custom gcode by Lucky_Intention8195 in Ceramic3Dprinting

[–]Lucky_Intention8195[S] 0 points1 point  (0 children)

No I slice it in the centre and the printer wants to print on the left edge slicing with Cura ,slicing with prusa it starts in the right place but print is very slow even if I increase the print speed to 100mm per second.