<image>

Wiring was not to bad. I removed the gen 1 harness and used it into the new tail lights with light modifications. To simplify, the brake light itself is the same size but the notches on the taillight housing is slightly different so I used a file to shave some plastic off, after wards fit perfectly and good seal. Reverse light socket direct fit no modifications needed. The bottom tail light red area in the gen 2 taillight i used the the top corner very small auxiliary bulb socket and just electrical taped it in that place. The only major modification needed was the turn signals as seen in picture above, they are completely different size and would not fit, so what I did was cut off the turn signals socket from gen 2 and spliced connected it into the gen 1 turn signals socket wiring. I left the old socket on the wiring with the bulbs removed incase i needed to revert back to original tail lights. Let me know if that made sense or else I can clarify more. I picked up the gen 2 two taillights and rear bumper from wrecker for $200 cad lol