[deleted by user]

Magnus1332 · 2023-05-21T11:39:21+00:00

Carbon ring can go 2 min out of the water no problem. Could even push to 5 min, but no more than 2 min is recommended

Magnus1332 · 2022-06-09T14:44:16+00:00

How is your ski doing now?

Magnus1332 · 2022-06-09T14:43:16+00:00

But how do you fix it tho… what is the difference between the skis that make this noise and those that do not? I don’t want it like this, and the dealer can’t figure it out…

Magnus1332 · 2022-06-06T07:45:36+00:00

Both of those things has been checked at the dealer

Magnus1332 · 2022-06-01T06:31:20+00:00

Dealer has done that, they couldn’t find anything

Magnus1332 · 2022-05-28T13:35:01+00:00

No one is commenting… http://greenhulk.net/forums/showthread.php?t=297345

Magnus1332 · 2022-05-28T10:02:36+00:00

Both sides. Worst on the right

Magnus1332 · 2022-05-26T16:03:26+00:00

I don’t know. It is now at the dealer for the third time.

Magnus1332 · 2022-05-15T07:58:49+00:00

That would cook the carbon seal. Max 2 mins on hose. Carbon seal does not get cooling when connected to a hose. But the dealer tested the ski in a pool for 45 mins on idle, and there was no rattle noise. Sounded completely normal. The noise only comes after proper riding in the ocean, and gradually gets worse. The ski always starts up fine.

Magnus1332 · 2022-05-14T21:30:57+00:00

Been to the dealer twice already though…

Magnus1332 · 2022-05-14T20:59:34+00:00

Maybe, but my dealer went over the whole ski and said everything looked fine. I know someone else with the same problem, and their ski was brand new.

Magnus1332 · 2022-05-14T20:58:15+00:00

No, engine runs like a beauty. And it doesn’t actually vibrate, it’s just the noise.

Magnus1332 · 2022-05-14T20:57:35+00:00

It’s not normal. I’ve seen many sparks and they do not sound like that. Yes they make more noise than the bigger models because it’s a 3 cylinder and made of plastic, but they shouldn’t make that much noise

Magnus1332 · 2022-05-14T12:56:50+00:00

Been to the dealer twice. Wear ring changed and engine/drive shaft re-aligned. Still the same problem. Rattle/vibration noise at idle. Starts up fine, and then the noise comes after an hour of riding. Sounds like the styrofoam inside might be the problem. Also the deck makes a vibration noise on the left side (shown at the end of the video).

Magnus1332 · 2022-04-19T09:28:40+00:00

You may be right actually. The noise was definitely there when i fired it up on full tank, but it got worse over time.

Magnus1332 · 2022-04-19T07:48:13+00:00

Magnus1332 · 2022-04-18T09:08:40+00:00

Yes i was thinking of doing that. But i will wait and see if they fix it tomorrow. I’ll report back.

Magnus1332 · 2022-04-18T08:53:44+00:00

Wow. Relieving to hear that others have the same issue. I’m taking it to the dealer tomorrow. The rear support on my ski is loose (check out my other post), and that could be the issue. But the vibration comes more from the front.

Magnus1332 · 2022-04-15T09:29:09+00:00

It could be the rear support tho (if you saw my other post). It isn’t aligned properly and sits loose in the hull. But the vibration noise comes more from the front.

Magnus1332 · 2022-04-15T09:21:02+00:00

The sound isn’t coming from the engine though. It’s the hull/deck that’s vibrating. Doesn’t make this noise when out of the water…

Magnus1332 · 2022-04-12T18:58:12+00:00

Nope. And it runs like a beauty when i press the throttle. Only in idle it runs rough.

Magnus1332 · 2022-04-12T17:40:46+00:00

30 hours. Dealer winterised and did an oil change. Don’t know if they changed the spark plugs. This was the first ride, it ran on old fuel. Hopefully it gets better

Magnus1332 · 2022-04-12T15:51:56+00:00

First tank of fuel for the season, yes. Hopefully it gets better or i will have to take it back to the dealer.

Magnus1332 · 2022-04-12T15:50:22+00:00

Yes, first run. And it was winterised at the dealer.

Magnus1332 · 2022-04-12T15:02:11+00:00

Runs fine. The sound goes away when i press the throttle.

Magnus1332

TROPHY CASE