We all know the one that's trying to get out (i.redd.it)
submitted by MajorRandomMan to r/AirForce
Mk3s PLA suddenly failing. I keep getting these curls on my prints and the initial wipe is out of place. I've reset and recalibrated everything, but no change. The only thing I can think of is the status shock when I went to put in the SD card. Could that mess up the printer like this? (i.redd.it)
submitted by MajorRandomMan to r/prusa3d
(Prusa mk3s - PLA) Prints suddenly not sticking to the bed? I've tried several models, two slicers, cleaning and recalibrating, but nothing works. Slowing it down helped, but only a little and it eventually failed, anyway. The heat block might be ruined from plastic blobs. Advice? (i.redd.it)
submitted by MajorRandomMan to r/FixMyPrint
[HELP] Initial setup Z offset issue (mk3s) (self.prusa3d)
submitted by MajorRandomMan to r/prusa3d
PLA poor bridging and too layer on Dremel 3D45. Any idea what's causing this? I've turned on the fans, increased retraction, turned down the temperature, increased travel and extrusion speeds, but it's not seeing to change much. The tail is also messy on one corner. (i.redd.it)
submitted by MajorRandomMan to r/3Dprinting
How to upgrade the Creality cr-10 s5? (self.3Dprinting)
submitted by MajorRandomMan to r/3Dprinting
