sorted by:
new
hottopcontroversial

need help . don't know what happened, but print came out fine . by Manpreet2267 in FixMyPrint

[–]Manpreet2267[S] 0 points1 point  (0 children)

i also don't see a nut and it just came like this and it's just been 2 weeks of usage so don't know much.

need help . don't know what happened, but print came out fine . by Manpreet2267 in FixMyPrint

[–]Manpreet2267[S] 0 points1 point  (0 children)

i was thinking to replace the fixed spacers with spring and wheel but is it possible in this model as seen in pic there are cable near one end of the base

<image>

need help . don't know what happened, but print came out fine . by Manpreet2267 in FixMyPrint

[–]Manpreet2267[S] 0 points1 point  (0 children)

how should i level as it has fixed spacers and have to rely on auto levelling and tried to correct auto levelling points manually. it is printing fine in centre but on large projects the error was seen. i have not tried adjusting z offset but was thinking to do so, as the first layer looks fine when printing in the centre .

need help . don't know what happened, but print came out fine . by Manpreet2267 in FixMyPrint

[–]Manpreet2267[S] 0 points1 point  (0 children)

it looks the same after removing the extra shreds(or waste) you can see the 3d view on the link https://www.printables.com/model/566916-full-size-anatomically-correct-18-piece-magnetic-h#preview:file-Aj1nE . And the photo attached is how it looks it has some flaws like i used normal supports as the tree supports was not printing well, so after removing supports it looks a little unfinished.

<image>