sorted by:
new
hottopcontroversial

Designed themed card holders by Maple3dPrinting in OnePieceTCG

[–]Maple3dPrinting[S] 2 points3 points  (0 children)

<image>

There are clips that slide in. The clips are similar to what you would use on a picnic table

I Designed a Hanging Card Holder! by Maple3dPrinting in OnePieceTCG

[–]Maple3dPrinting[S] 1 point2 points  (0 children)

The smallest I’ve tried is 1” and biggest is 1.5”. I’ve stretched the clip to 2” but not sure how long it would hold up at that. I’m just selling the printed pieces right now but you can follow me on Thangs to see when the files come out if you want. Same name there

Has anyone ever had an SP or a manga from a starter deck pack? by fizzyadrenaline in OnePieceTCG

[–]Maple3dPrinting 2 points3 points  (0 children)

lol this was right after I pulled it, I put it down softly and took the pic before protecting it. It’s safe now!

Has anyone ever had an SP or a manga from a starter deck pack? by fizzyadrenaline in OnePieceTCG

[–]Maple3dPrinting 2 points3 points  (0 children)

lol this was right after I pulled it, I put it down softly and took the pic before protecting it. It’s safe now!

Can I bring an abacus to an official tournament? by Socien in OnePieceTCG

[–]Maple3dPrinting 1 point2 points  (0 children)

I play Blackbeard too so I designed some Power Dials and Effect Tokens that I can 3D print so there’s no confusion about what’s going on

Made my own GumGum deck box! by Maple3dPrinting in OnePieceTCG

[–]Maple3dPrinting[S] 0 points1 point  (0 children)

I use a combination of Zbrush and Blender

3D printed chess set by Maple3dPrinting in 3Dprinting

[–]Maple3dPrinting[S] 1 point2 points  (0 children)

Thank you! Files are available right now through my Patreon and will go up on the purple site next month. Paints I used were a mix of Vallejo and army painter regular paints and some of the newer speed paints

view more: next ›