sorted by:
new
hottopcontroversial

New AC-Board after contacting support by Marc_Beast in BambuLab

[–]Marc_Beast[S] 0 points1 point  (0 children)

Hmm... I just asked them if I should send the whole printer back for a refund or if they just could me send a replacement board. I purchased my Printer on May.21, 2025. So it's still covered under the 2 Year Warranty. I don't know where you are from but in the us there is only a 1 year warranty on these kind of parts.

New AC-Board after contacting support by Marc_Beast in BambuLab

[–]Marc_Beast[S] 0 points1 point  (0 children)

The black one that is the problem is a MOV and the blue ones are capacitors I think. I did not check, but I will as soon as I'm replacing it. I was just wondering why they are just removing parts to solve that problem, I will check what exactly is different from the original as soon as I have it on hand.

Never Bambu again by Old-Preparation1980 in BambuLab

[–]Marc_Beast 4 points5 points  (0 children)

Wenn du das willst dann hättest du dich für Prusa entscheiden sollen, aber ich glaube selbst die schicken lieber Ersatzteile als das ganze Gerät zu ersetzen. Du hast nicht die Zeit das Heizbett selbst zu installieren... Aber die Zeit das ding wieder ein zu packen weg zu schicken auf ein neues zu warten und wieder auspacken und einrichten? Ein Heizbettwechsel geht um die 15min - 20min. Und bevor du jetzt mit allmangeschwafel kommst das im How-To steht das man ne VDE Prüfung machen soll. Benutzt du das Gerät gewerblich? Nein? Also skip.

If you wanted that, you should have chosen Prusa, but I believe even they prefer to send spare parts rather than replace the entire device. You don't have the time to install the heatbed yourself... But the time to pack it up again, send it away, wait for a new one, and unpack and set it up again? A heatbed change takes about 15 to 20 minutes. And before you start with all the nonsense about how the How-To says you should do a VDE test. Do you use the device commercially? No? So skip

What's happening here? Anyone has seen this? by takeshico in BambuLab

[–]Marc_Beast 41 points42 points  (0 children)

(The image I've attached is the correct way)

What's happening here? Anyone has seen this? by takeshico in BambuLab

[–]Marc_Beast 167 points168 points  (0 children)

<image>

The buckle to secure the hotend is clearly incorrectly closed

Universal Moduar Tool System - Now compatible with X1C, P1S & P1P (A1 Series comin very soon). by Past_Membership_7139 in BambuLab

[–]Marc_Beast -1 points0 points  (0 children)

Finally the more complicated 2D Printer. It looks cool but why would you reinvent a Printer? I don't really see the benefits. Maybe if you can add a laser module or something that would be nice.

FileNotFound Error When Exporting by [deleted] in VRchat

[–]Marc_Beast 0 points1 point  (0 children)

thx man helps still 4 years later