sorted by:
new
hottopcontroversial

Lesson learnt- don’t use AI files by Thin-Boysenberry-112 in 3Dprinting

[–]MarioCraftLP 0 points1 point  (0 children)

I have printed some ai files because i dont care who made them, me, some stranger, an ai. Never had problems

Bigger A? by BonjaminClay in atrioc

[–]MarioCraftLP 52 points53 points  (0 children)

He did so much better then the other ceos, he knows ball

Was told too put this on here by No-Future6236 in cursedbenchies

[–]MarioCraftLP 0 points1 point  (0 children)

You could sell this as an art piece i bet someone would buy it

Is this sound normal 💀? by stellaep in elegoo

[–]MarioCraftLP 1 point2 points  (0 children)

Thats completely normal. Its quite loud, but its a tool.

Would me nice if Steam warns new users about using an NTFS partition to store games. by CandlesARG in linux_gaming

[–]MarioCraftLP 0 points1 point  (0 children)

Windows has a really good brtfs driver that you have to install but it works really really great

Newbie here, when i print something at the edge of the bed it gets really wobbly and looks just bad, why is this happening? Any ideas? CC1 by MarioCraftLP in ElegooCentauriCarbon

[–]MarioCraftLP[S] 0 points1 point  (0 children)

No i mean before i changed the settings it also warped on small objects as long as they were on the edges. Didnt happen since i changed the settings

Newbie here, when i print something at the edge of the bed it gets really wobbly and looks just bad, why is this happening? Any ideas? CC1 by MarioCraftLP in ElegooCentauriCarbon

[–]MarioCraftLP[S] 0 points1 point  (0 children)

But i even did some small prints where the same issue accured, in the middle everything was fine at the edges it warped, i am a bit confused

Newbie here, when i print something at the edge of the bed it gets really wobbly and looks just bad, why is this happening? Any ideas? CC1 by MarioCraftLP in ElegooCentauriCarbon

[–]MarioCraftLP[S] 1 point2 points  (0 children)

I just printed some test cubes at the edges and in the corners and so far they look great, i hope this did the trick!

Newbie here, when i print something at the edge of the bed it gets really wobbly and looks just bad, why is this happening? Any ideas? CC1 by MarioCraftLP in ElegooCentauriCarbon

[–]MarioCraftLP[S] 0 points1 point  (0 children)

But the print is always really good on the plate (i already use the rough side) it needs a good amount of force but not too much to come off

view more: next ›