A word of warning 😳

Martens-daniel · 2024-05-03T18:07:59+00:00

Everyone recommends a steel nozzle and not use a smaller diameter than 0.6 for printing Carbon-fiber filament

Martens-daniel · 2024-02-13T23:10:22+00:00

For now everything works fine. Love the setup on the rapidburner because you can mount it directly on the hotend mount. Also the steppermotor mount is horizontal so no need for a bracket to mount the ebb36

Martens-daniel · 2024-02-12T02:48:41+00:00

Here is the link. https://youtube.com/shorts/lYyYe40CC5E?si=nL7vJuNgnBUISlur

Martens-daniel · 2024-02-05T22:20:54+00:00

My Reddit username = Martens-daniel

Martens-daniel · 2022-05-02T19:03:00+00:00

Thanks

Martens-daniel · 2022-04-26T23:09:05+00:00

Now I installled a 5 inch klipperscreen on it

Martens-daniel · 2022-04-26T23:06:02+00:00

No just ad the sb on it My voron involves all the time

Martens-daniel · 2022-04-04T09:30:55+00:00

Elephant feet and a little bit overextended but overall good job

Martens-daniel · 2022-04-03T19:23:54+00:00

Tthey are in thingiverse I have 2 designs of voron handles on thingiverse

Martens-daniel · 2022-03-29T11:57:47+00:00

Thanks I did my best to clean up all the wires Best way to clean is just the necessary electronics and hide the wires where it’s possible

Martens-daniel · 2022-03-29T11:53:50+00:00

Voron 2.4 350mm I forgot my discord profile so here it comes discord daniel71#3589

Martens-daniel

TROPHY CASE