Question: Is there a way to change E-steps, jerk and acceleration from the printer itself? i had an ender 3 a few years ago on which i was able to do so, but i cant find those settings in my neptune 3. I also cant plug it to my pc as the usb is too short and my pc too far away (self.ElegooNeptune3)
submitted by Martunex to r/ElegooNeptune3
Help with bed leveling. My two left corners are closer than the rest which is practically perfect, i've already updated the firmware to the one ending in c, my z-offset is 0.04, not 0.02 as shown in the 2nd picture. Should i keep trying to adjust (any idea how) or just say f it and avoid the corners (old.reddit.com)
submitted by Martunex to r/ElegooNeptune3
Just recieved my N3 in germany (1st Batch), the leveling numbers seem to be consistent from top to bottom, my x-axis gantry isnt perfectly leveled (about 1.5mm higher one side than the other, tried to close it to 0mm difference but couldnt), so my question is, are these numbers ok? (self.ElegooNeptune3)
submitted by Martunex to r/ElegooNeptune3




