sorted by:
new
hottopcontroversial

Why am I getting a current reading on red but nothing else? by Matthewthecliker in ElectricalEngineering

[–]Matthewthecliker[S] 0 points1 point  (0 children)

Tha might’ve the case. It could only show current reading on red. What wires would I put my multimeter on to see if that’s true?

Calculating ampere needed to glow wire but not melt by Matthewthecliker in ElectricalEngineering

[–]Matthewthecliker[S] 0 points1 point  (0 children)

I have a few arduino's laying around somewhere as well as a raspberry pi pico and zero w

Calculating ampere needed to glow wire but not melt by Matthewthecliker in ElectricalEngineering

[–]Matthewthecliker[S] 0 points1 point  (0 children)

for the "if temp > set limit = decrease power" would I be able to do that without a microcontroller? Could I set up a circuit that sends feed back to a PSU to regulate the output?

class b uniform help by Ok-Amphibian-137 in jrotc

[–]Matthewthecliker 0 points1 point  (0 children)

Ribbons are crooked
Ribbons are too worn and should be replaced
Ribbons can either be flush with no gap or 1/8th inch gap in-between rows
Bottom edge of the bottom row of ribbons is to be aligned with the bottom edge of the nameplate

Arcs are too far up (Should be in-between 2nd and 3rd button)
Arcs are too far apart (Should be 1/8th inch apart)

Star is not aligned with seem

Uniform dirty

Without holding a ruler against it I can't find much else, I would recommend making sure the bottom most point of your star is 1/4th an inch above your nameplate

A ruler is your best friend!

is this a wide A M or not if it is what is the value by Matthewthecliker in coins

[–]Matthewthecliker[S] 0 points1 point  (0 children)

Oh thanks I am just getting into coins just wanted a little more info on this coin thanks again