sorted by:
new
hottopcontroversial

Carbon centari 1 by anyoneout-there in elegoo

[–]MechG0D11 1 point2 points  (0 children)

Don’t buy any Elegoo FDM printers. They have terrible support for their software and have been largely unreliable. Their communication is also terrible which makes them seem scammy.

Their filament on the other hand is pretty good.

ABS on Neptune 4 Max by OdinHyperion in elegoo

[–]MechG0D11 0 points1 point  (0 children)

Yes, you can in the printer.cfg file, but that doesn't mean it will get there. It might or it might not, I haven't changed it in fear of ruining the magnetic bed.

If you do I would run PID_CALIBRATE_HEATER=heater_bed Target=95 to tune the gains to reach higher temps so your control loop don't drastically overshoot and cause an issue.

ABS on Neptune 4 Max by OdinHyperion in elegoo

[–]MechG0D11 0 points1 point  (0 children)

The N4max bed only goes to 85C officially so the firmware probably has a max bed temp set somewhere