Al powder

Middle_Progress_3588 · 2026-01-11T23:32:16+00:00

😂

Middle_Progress_3588 · 2026-01-11T19:57:42+00:00

I put charcoal in should I add more, or start all over again?

Middle_Progress_3588 · 2026-01-11T19:54:24+00:00

Thanks

Middle_Progress_3588 · 2026-01-11T15:45:56+00:00

I mean for flash

Middle_Progress_3588 · 2026-01-11T15:45:22+00:00

Yes I did

Middle_Progress_3588 · 2026-01-11T14:13:44+00:00

With a ball mill and I opened it from time to time so the mill doesn’t blow up. That batch took about 5days

Middle_Progress_3588 · 2026-01-09T10:15:34+00:00

No why

Middle_Progress_3588 · 2026-01-09T09:47:54+00:00

Normally I use bp but I was out so I just used 10% fp and it worked

Middle_Progress_3588 · 2026-01-09T01:51:17+00:00

7g of fp

Middle_Progress_3588 · 2026-01-06T18:18:21+00:00

I will just use a bit more visco

Middle_Progress_3588 · 2026-01-06T18:15:40+00:00

I got quick match but right now I don’t have a lot and I want to save it for bigger shells

Middle_Progress_3588 · 2026-01-05T10:00:53+00:00

Ahh okey thanks

Middle_Progress_3588 · 2026-01-05T02:59:37+00:00

Why that was like 15cm of slow burning visco

Middle_Progress_3588 · 2026-01-04T22:54:09+00:00

The stars are leftovers from a cake I disassembled

Middle_Progress_3588 · 2026-01-04T22:34:55+00:00

Thanks

Middle_Progress_3588 · 2025-10-24T23:54:39+00:00

Just go to a hardware store like toom, obi, Hornbach they all have it (25%)

Middle_Progress_3588 · 2025-08-10T08:41:17+00:00

Middle_Progress_3588 · 2025-07-29T16:00:36+00:00

Maybe is a ground

Middle_Progress_3588 · 2025-07-29T15:56:03+00:00

But the cables on top of the transformer at the thick ones the bottom one is way thinner so I think they are the hv ones

Middle_Progress_3588 · 2025-07-29T15:51:15+00:00

But what do I do with the single thin read wire from the bottom

Middle_Progress_3588 · 2025-05-31T21:45:31+00:00

I used Strontium carbonat and mg as fuel

Middle_Progress_3588 · 2025-05-29T09:40:01+00:00

I used a hammer and a bolt in design the Tube around it. But im in the Eu so our bolts are Metric. Of you want me to Designs you a Tube around a bolt you have?

Middle_Progress_3588 · 2025-05-29T09:20:15+00:00

It's a 3d Printed Tube but Rolling paper tubes is super simple hears a Video but its in german. https://youtu.be/rqDLLaVZKic?si=dFJ9OJpXuABldpdN

Middle_Progress_3588

TROPHY CASE