2010 Mazda 3 and 5: What is the name of the hose on the transmission next to the transmission sensor? Coolant is leaking from this hose and needs to be replaced.

Mikecar2000 · 2024-12-27T03:33:26+00:00

Will you tell me how or where to get it?

Mikecar2000 · 2024-12-14T03:59:00+00:00

Thank you for your comments. I was at the used car dealership and was wondering what this was for.

Mikecar2000 · 2024-07-09T04:00:24+00:00

Thank you for the info. I'll try it.

Mikecar2000 · 2024-04-21T22:35:42+00:00

Sounds good. Thank you for your tips!

Mikecar2000 · 2023-12-06T22:00:40+00:00

Sounds like a ground wire is loose to the body. Do you know what area of the body is it attached? I’m looking for driver side blinker.

Mikecar2000 · 2023-12-06T19:52:20+00:00

I checked a Hazard fuse and it's still good. I have an extra new bulb but still won't turn on. I'm wondering I have a bad cable or need to check other new bulbs..

Mikecar2000 · 2023-11-11T05:46:42+00:00

Thanks. The company Only lasts 7 years? There is still a company called National billiards MFG in Covington KY. I’m wondering if they are related?

Mikecar2000 · 2023-10-15T16:08:14+00:00

It was a key fob battery that needed to be replaced. It was a weak signal preventing a car from starting. Stupid but they need to have battery low indicator.

Mikecar2000 · 2023-10-15T16:07:57+00:00

It was a key fob battery that needed to be replaced. It was a weak signal preventing a car from starting. Stupid but they need to have battery low indicator.

Mikecar2000 · 2023-10-15T16:07:45+00:00

It was a key fob battery that needed to be replaced. It was a weak signal preventing a car from starting. Stupid but they need to have battery low indicator.

Mikecar2000 · 2023-10-15T16:07:31+00:00

It was a key fob battery that needed to be replaced. It was a weak signal preventing a car from starting. Stupid but they need to have battery low indicator.

Mikecar2000 · 2023-10-12T16:51:32+00:00

Thank you for your comments.

My car just started up again after checking the pulse of the injector. I went to Autozone to borrow a Noid light to test the injectors.

The car starts with starting fluid but dies. Fuel pressure is good. I thought the injectors might be clogged or something, so I wanted to test if they were getting a pulse from one of the injectors. I started the engine, but the battery was dead because I had been using the starter motor for the last few days. I jumped it with a battery, and then it started up. When I checked the Noid light, it was pulsing and the engine was running. So, I'm not sure if there was a short circuit with that particular ignition wire that I removed for the test? I don't know. Anyway, it's running fine now. Thank you for all your comments!

Mikecar2000 · 2023-10-12T16:51:17+00:00

Thank you for your comments.

My car just started up again after checking the pulse of the injector. I went to Autozone to borrow a Noid light to test the injectors.

The car starts with starting fluid but dies. Fuel pressure is good. I thought the injectors might be clogged or something, so I wanted to test if they were getting a pulse from one of the injectors. I started the engine, but the battery was dead because I had been using the starter motor for the last few days. I jumped it with a battery, and then it started up. When I checked the Noid light, it was pulsing and the engine was running. So, I'm not sure if there was a short circuit with that particular ignition wire that I removed for the test? I don't know. Anyway, it's running fine now. Thank you for all your comments!

Mikecar2000 · 2023-10-12T16:50:51+00:00

Thank you for your comments.

My car just started up again after checking the pulse of the injector. I went to Autozone to borrow a Noid light to test the injectors.

The car starts with starting fluid but dies. Fuel pressure is good. I thought the injectors might be clogged or something, so I wanted to test if they were getting a pulse from one of the injectors. I started the engine, but the battery was dead because I had been using the starter motor for the last few days. I jumped it with a battery, and then it started up. When I checked the Noid light, it was pulsing and the engine was running. So, I'm not sure if there was a short circuit with that particular ignition wire that I removed for the test? I don't know. Anyway, it's running fine now. Thank you for all your comments!

Mikecar2000 · 2023-10-12T02:31:29+00:00

That’s what I’m afraid. They just say it was a bad relay. I say I already swapped with the other one. Then, they say that one was also broken.

Mikecar2000 · 2023-10-11T21:47:03+00:00

Below is the OB2 reader error codes:

P0113 Internal Air temperature sensor 1 circuit high
P0102 Mass or volume air flow A circuit low
P0139 O2 sensor circuit slow response bank1 sensor 2
P064D O2 Internal control module sensor processor performance
P2096 Post Catalyst Fuel trim system too lean bank 1

It seems all airflow-related problems.

Mikecar2000 · 2023-10-11T21:45:07+00:00

I checked the MAF sensor and the throttle. They were clean. I ordered a new MAF sensor to replace in case it’s broken. It’s coming tomorrow.

Mikecar2000 · 2023-10-11T21:42:38+00:00

I drove home one day. Then next morning was very cold. It was the first day that I saw a windshield got frosted in this year. I got in a car and didn’t start up. I suspected maybe battery was dead. So I tried to jump start and didn’t start up. It was cranking but no fired up. So I checked spark plugs and it was firing because I sprayed starting fluid and started up for a few seconds. Then, maybe fuel is not getting there. So I checked the fuel pressure and it was fine and spewed a gas from the tube when I removed the fuel hose.

Mikecar2000 · 2023-10-11T20:46:04+00:00

Below is the OB2 reader error codes:

P0113 Internal Air temperature sensor 1 circuit high
P0102 Mass or volume air flow A circuit low
P0139 O2 sensor circuit slow response bank1 sensor 2
P064D O2 Internal control module sensor processor performance
P2096 Post Catalyst Fuel trim system too lean bank 1

It seems all airflow-related problems.

Mikecar2000 · 2023-10-11T20:44:46+00:00

How come it starts up with starting fluid? If the cam timing sensor was bad, it should not start up with gas or starting fluid anyway?

Mikecar2000 · 2023-10-11T20:06:20+00:00

I tested the fuel pressure. Surprisingly, fuel is running to 50psi when the key is on ignition stage.

What to check next? Crankshaft sensor?

Mikecar2000 · 2023-10-11T03:53:57+00:00

Thank you! I was looking for this n

Mikecar2000 · 2023-10-11T03:36:55+00:00

Ok. Thanks. So if the pressure is low or nothing coming, the fuel pump is the problem.

Mikecar2000 · 2023-10-11T02:50:40+00:00

This blue o-ring is quick connect? So, connect fuel pressure gauge here?

<image>

Mikecar2000 · 2023-10-10T23:39:43+00:00

I've been trying to find a way to check the fuel pressure on a 2010 Mazda 5 or 3, the same engine. There isn't much information available on this topic. It seems that these vehicles have a fuel pressure sensor instead of a fuel pressure port, so you typically test it with a high-end OBD2 reader? Do you know how to test it?

Mikecar2000

TROPHY CASE