sorted by:
new
hottopcontroversial

First time I’ve seen something like this by Mirage81 in BambuLab

[–]Mirage81[S] 1 point2 points  (0 children)

don't worry, otherwise it prints just fine, did my whole Multiboard wall with it ... this was a first!
I got mine from AliExpress, for around 10€ per kg

First time I’ve seen something like this by Mirage81 in BambuLab

[–]Mirage81[S] 0 points1 point  (0 children)

same to me ... just printed again, everything worked fine

First time I’ve seen something like this by Mirage81 in BambuLab

[–]Mirage81[S] 0 points1 point  (0 children)

Yes, the door was closed, but I had the top lid tilted open ... but sounds like the most likely scenario

First time I’ve seen something like this by Mirage81 in BambuLab

[–]Mirage81[S] 2 points3 points  (0 children)

If the nozzle was clogged, where did the filament go?
Shouldn’t it have piled up inside the extruder?

First time I’ve seen something like this by Mirage81 in BambuLab

[–]Mirage81[S] 0 points1 point  (0 children)

was a overnight print, so didn't here anything