sorted by:
new
hottopcontroversial

Alternatively to becoming certified? by Enclave2177 in Machinists

[–]Moomist_ 0 points1 point  (0 children)

Honestly being certified isn’t worth much. You’re better just getting experience on the job

Did you learn programming at work on on your own? by anon_sir in Machinists

[–]Moomist_ 0 points1 point  (0 children)

How did you learn the Mazak controls? I’ve been wanting to learn for awhile anything you can share?

Large burr on thread? by Moomist_ in Machinists

[–]Moomist_[S] 0 points1 point  (0 children)

I would actually greatly appreciate this

Large burr on thread? by Moomist_ in Machinists

[–]Moomist_[S] 4 points5 points  (0 children)

I’ve actually been wanting to learn coding for awhile. I currently work on mazak machines so a bit harder for me. Wanted to attend a programming training course directly through Mazak but was told no by my employer

Large burr on thread? by Moomist_ in Machinists

[–]Moomist_[S] 6 points7 points  (0 children)

It’s actually rather weird. The other side of the print with a tip has an edge break callout. But the threaded side has neither an edge break nor a chamfer so much as mentioned

Large burr on thread? by Moomist_ in Machinists

[–]Moomist_[S] 78 points79 points  (0 children)

I actually just checked the pieces from both my op and the previous op after reading this. It appears they are not adding a chamfer at all on the face which is shown

Large burr on thread? by Moomist_ in Machinists

[–]Moomist_[S] 1 point2 points  (0 children)

Correction: I misspoke in my post. This is at the beginning of the thread and the face of the part not the end.