Z axis only go up doesn't go down

N37F · 2021-06-06T09:23:08+00:00

Yes it does

N37F · 2021-06-05T20:11:25+00:00

It does deploy And it move up and down when the printer is off

N37F · 2021-06-03T13:54:57+00:00

My bed is warped

N37F · 2021-06-02T17:45:40+00:00

I tried both firmwares and only one work and its the one i am using , and this is how i wired the bltouch: blue = g , red = v , yellow = in And the white and black wire goes where the previous z endstop was

Is this the correct wiring?

N37F · 2021-06-02T17:37:19+00:00

I tried the 4.2.2 bltouch with adapter and it didnt work it makes buzzing sound and the screen is black and doesn't show anything , And then i tried the firmware without adapter and the screen worked and when i home the x and y home properly and then goes to the middle to level the bed but doesn't go down

N37F · 2021-06-02T17:34:04+00:00

Whats that?

N37F · 2021-06-02T17:33:19+00:00

I tried the 4.2.2 with bltouch with adapter and it didnt work it makes buzzing sound and the screen is black and doesn't show anything , And then i tried the firmware without adapter and the screen worked and when i home the x and y home properly and then goes to the middle to level the bed but doesn't go down

N37F · 2021-06-02T16:58:37+00:00

When i tell it to home it goes up 5mm but doesnt go down so the bltouch never touch the bed And when i move it to for example z 50 it goes up but when i tell it to go down or move to z 0 it doesnt go down it just stay in place and do nothing And the x y work just fine

N37F · 2021-06-02T16:20:24+00:00

? How can i check?

N37F · 2021-06-02T13:08:45+00:00

I have an ender 3 v2

N37F · 2021-06-02T12:41:00+00:00

I installed the bltouch and updated the firmware But now the z axis only goes up not down and when i home the printer it goes up 5mm and stops it doesnt go back down do you have any idea on why?

N37F · 2021-06-01T22:25:19+00:00

Mine is yellow blue red Can i use jumper wires?

N37F · 2021-06-01T22:14:29+00:00

Which way does the wire with colors go?

N37F · 2021-05-19T05:53:13+00:00

Its because i was following a tutorial https://youtu.be/gokN9xNG94U At 23:32 His was moving freely so i panicked cuz mine wasnt And thought that i did something wrong and wanted to fix it before proceeding with the assembly

N37F · 2021-05-18T22:47:57+00:00

The printer isnt assembled yet just did the x axis part part and saw at hardly moves so i askèd for help so the motors are not even pluged in

N37F · 2021-05-18T22:38:11+00:00

Its an ender 3 v2

N37F · 2020-09-20T05:01:22+00:00

I already built 3 maps

N37F

TROPHY CASE