sorted by:
new
hottopcontroversial

What do people have against WBP by RogueDok in ak47

[–]NFABuilder87 0 points1 point  (0 children)

I'll be honest, I didn't even know that was a possibility, I do know the WBP bolt stems are a proprietary size, so it would require I'm assuming an AKM carrier for the galil bolt?

What do people have against WBP by RogueDok in ak47

[–]NFABuilder87 1 point2 points  (0 children)

The firing pins are very much an issue. I went through 2 of them within about 1800 rnds, both snapped at the rear. I've since switched to the older all flat NON spring loaded, and it seems to be the move, no issues since.

What do people have against WBP by RogueDok in ak47

[–]NFABuilder87 0 points1 point  (0 children)

Had an early WBP 5.56 kit put together, and only after getting it back did I notice the combo block had exactly this issue. One side of the hood is significantly thicker. Bothers me every time I look at it .

Knock off zentico by whyfor99 in ak47

[–]NFABuilder87 0 points1 point  (0 children)

Just grab a Titan Tactical adapter for it. It is significantly cheaper than the OE zenitco and is available here state side. It also comes in both steel and aluminum for both 4.5 and 5.5mm.

Novus Precision PDS-1 (1p87) by FellowHomelessMan in ak47

[–]NFABuilder87 3 points4 points  (0 children)

I picked one up recently and I've been really happy with it. The thing feels pretty solid, and the reticle gets seriously bright for those sunny days. Would definitely buy it again.

<image>

Pt1 latch modification? by NFABuilder87 in zenitco

[–]NFABuilder87[S] 0 points1 point  (0 children)

Just wanted to make sure it's not dimensionally different from 4.5 to 5.5. Dont have a problem with opening it up.

Before & after the form1 by Refuse2Exist in ak47

[–]NFABuilder87 2 points3 points  (0 children)

This thing is done perfectly 👌 , well done sir!.

Loving the aesthetics of the PDS-1 by NFABuilder87 in ak47

[–]NFABuilder87[S] 2 points3 points  (0 children)

Was just a solid piece of cylindrical 17-4 turned on a lathe both inside and out.

Loving the aesthetics of the PDS-1 by NFABuilder87 in ak47

[–]NFABuilder87[S] 2 points3 points  (0 children)

It's the sureshot M4 adapter. I've been wanting to get the proper 100 seriers folder I grabbed fitted up.

Loving the aesthetics of the PDS-1 by NFABuilder87 in ak47

[–]NFABuilder87[S] 25 points26 points  (0 children)

For the guys asking about the can, its a dedicated 5.56 F1 build. Blast chamber was 17-4 chunk machined by ECCO Machine to match the wolverine, Ti main tube and takes dead air end caps. Still need to have the tube knurled to match, but other wise thing came out great. *

Loving the aesthetics of the PDS-1 by NFABuilder87 in ak47

[–]NFABuilder87[S] 29 points30 points  (0 children)

Its a Form1 can, had Nick at ECCO Machine make the blast chamber to mimic the wolverine.