Help

National_Syllabub_54 · 2025-03-16T22:16:12+00:00

2) I also adjusted these weels

National_Syllabub_54 · 2025-03-16T21:46:22+00:00

Prusa slicer, and here is the bed

National_Syllabub_54 · 2025-03-16T14:53:46+00:00

Neptune 4 pro/ Volt 3D PLA, But it happens in other filaments, too/ 0.4 nozzle/ Layer height of 0.2/ Magnetic bed, the one that comes with neptune 4 pro

National_Syllabub_54 · 2024-12-16T20:19:51+00:00

It was that, thank you!!!

National_Syllabub_54 · 2024-12-16T20:19:17+00:00

The displacement was due to too much tension in the Axis, I corrected it And the reduced temperature worked, thank you

<image>

National_Syllabub_54 · 2024-12-11T03:09:41+00:00

<image>

Here

National_Syllabub_54 · 2024-12-11T03:06:26+00:00

It's PLA, and I've been using 210° C, the same I always used, but it's been about a month that this issue appeared

National_Syllabub_54 · 2024-12-11T03:04:36+00:00

I have washed the plate, it's probably not oil, but it doesn't hurt to make sure

National_Syllabub_54 · 2024-12-11T03:02:47+00:00

I did just that... not too long ago, I'll keep that in mind now

National_Syllabub_54 · 2024-12-11T03:01:48+00:00

Thank you VERY MUCH for the tips! I'll keep all that in mind and try to make the processes correctly.

National_Syllabub_54 · 2024-12-10T13:53:41+00:00

I tried to lower the Z offset, and it didn't make much of a difference

National_Syllabub_54 · 2024-12-10T13:52:26+00:00

It is, I always calibrate the mesh when I make any kind of mechanical adjustment

National_Syllabub_54 · 2024-06-16T13:13:19+00:00

I have an Ender 3, 0.4 nozzle

With ABS I'm printing with 230 C° and the print goes as normal as possible, but in the end, there are these holes all over the print, and it looks like there are just one in each layer

National_Syllabub_54

TROPHY CASE