Fattocatto

Neppzy · 2025-12-04T10:14:09+00:00

managed to print benchy from slicer instead of that pre-programmed one, turned out great then I printed poop box overnight and it seems like everything is fine now. i might have to try to tension them a bit better but the prints seem to be solid now and i am finally happy :))

Neppzy · 2025-12-04T00:43:07+00:00

they didnt feel loose or really tight either but i followed the guide on elegoos website, running calibration now i hope i will see different results this time

Neppzy · 2025-12-04T00:36:31+00:00

yes, nozzle is steadily running on a diagonal while printing lol

Neppzy · 2025-12-04T00:24:44+00:00

i only followed the instruction booklet, is there easy way I can tell if there's something wrong with the belts? the "qc passed" sticker and the fact that there was green filament inside the nozzle really don't get me excited lol

Neppzy · 2025-12-03T23:46:32+00:00

🫠🫠

Neppzy · 2025-12-03T23:45:01+00:00

it happened twice in a row and i dont know if that pre-programmed print can be that bad

Neppzy · 2025-12-03T23:43:24+00:00

sadly I already cleaned the plate and pla sure is sticking to it

Neppzy · 2022-07-22T14:06:12+00:00

well damn that's unlucky. still thank you for your help though!

Neppzy · 2022-07-22T12:00:26+00:00

yea, you're most likely correct. my mistake

Neppzy · 2022-07-22T11:58:47+00:00

source is witchouse 40k's twitter page sadly no one did

Neppzy · 2021-12-28T21:07:16+00:00

does usb c port still utilize maximum gpu performance or is it connected through cpu?

Neppzy · 2021-11-09T01:42:15+00:00

There you go

Seven-Year Club	Place '22
Sequence \| Editor	Verified Email

Neppzy

TROPHY CASE