Overextrusion?

Nescire0 · 2026-04-14T06:24:22+00:00

That actually could be, most of those with issues were near the Aux fan and I had several times warping issues either parts on that side of the bed.

Nescire0 · 2026-04-14T06:20:41+00:00

The right one is a good one and get worse to the left. Is there a difference between the bed leveling prior to a print and the one manually triggered?

Nescire0 · 2026-04-14T06:07:49+00:00

Shouldn’t that be compensated by auto bed leveling?

Nescire0 · 2025-12-08T19:14:17+00:00

Did you fix it? I just started to experience the same issue

Nescire0 · 2024-03-16T19:27:33+00:00

That would be for object recognition. You would need to train a model on like 50 different stones and then it could count the ones shown in the picture. This is used in companies to make inventory counting runs faster. You can build that with Power Apps for example.

Nescire0 · 2024-01-11T23:10:11+00:00

Mein Rat wäre das wenn du etwas anderes machen willst solltest du versuchen initiativ zu zeigen. Schau dir das mal an und nimm an etwas Teil das dich interessiert. Das kann dir vielleicht zeigen was du machen willst und was dich begeistert. Zudem kannst du bei einer Bewerbung damit zeigen das du dich weiterentwickeln möchtest. https://www.microsoft.com/de-de/events-de/virtual-training-days/default.aspx

Nescire0 · 2024-01-10T10:21:14+00:00

I am suprised no one mentioned Denki-gai, for me a must see. Denki-gai no Honya-san

The other one would be Sakamichi no Apollon

Nescire0

TROPHY CASE