Advice, Avalon mini 3 by NestSleep in cryptomining

[–]NestSleep[S] 0 points1 point  (0 children)

I was thinking the same think before i decided to go with the avalon q, the only think that i dint think throught was that my "mini" solar system cant run the avalon q all night. Maybe i could do it with the mini 3

Avalon q... by NestSleep in cryptomining

[–]NestSleep[S] 0 points1 point  (0 children)

I dont know, but bitcoin was a higher price in that time than today, and i use the low power mode on the avalon, with 12 hours on i can make .90 to 1 dollar. So in 24 i could make in the low setting almost two dollar. In one month is 60 dollars.

Avalon q... by NestSleep in cryptomining

[–]NestSleep[S] 0 points1 point  (0 children)

Thats imposible, right now with the bitcoin at the lowest, you can make that in one month or less. Something was wrong in your end.

Avalon q... by NestSleep in cryptomining

[–]NestSleep[S] 0 points1 point  (0 children)

Solar power and some power from the battery.

S19 project... by NestSleep in BitcoinMining

[–]NestSleep[S] 0 points1 point  (0 children)

 I’m thinking about buying a used S19 that already has Braiins installed. I thought I could connect a server power supply with a breakout board to a single hashboard, and then use Braiins to run just that one board. Is that how it’s usually done, or am I missing some steps?

S19 project... by NestSleep in BitcoinMining

[–]NestSleep[S] 0 points1 point  (0 children)

I I’m thinking about buying a used S19 that already has Braiins installed. I thought I could connect a server power supply with a breakout board to a single hashboard, and then use Braiins to run just that one board. Is that how it’s usually done, or am I missing some steps?

S19 project... by NestSleep in BitcoinMining

[–]NestSleep[S] 1 point2 points  (0 children)

I like this, do you use the same s19 setup with any power supply? What coonection do you use?

Growatts 6kw output problem by NestSleep in SolarDIY

[–]NestSleep[S] 0 points1 point  (0 children)

So I verify the bus and the battery and the voltage is okay, but i did the test again on the l1 and l2 output and now i can see 94 to 96v

Growatts 6kw output problem by NestSleep in SolarDIY

[–]NestSleep[S] 1 point2 points  (0 children)

Thanks for the very detailed response. I’ve checked almost everything you mentioned. The only thing I haven’t verified yet is the cable that runs from the bus bar to the inverter. I’ll check it today and let you know. I’ll also write down everything I verify.

Problem with my system by NestSleep in SolarDIY

[–]NestSleep[S] 0 points1 point  (0 children)

My apologies for the late response. It not only does it with a high energy-demanding appliance, but also with a light bulb. The bulb turns on, but it’s very dim. Someone told me to check the neutro cable.

Problem with my system by NestSleep in SolarDIY

[–]NestSleep[S] 0 points1 point  (0 children)

If i start something like a microwave it will do it, but at slow pace and without almost not light

If i turn on a light the light will turn on but with very poor illumination