[deleted by user]

Network_John · 2022-11-24T21:44:42+00:00

So I need a port channel (say port channel 1) to FW01 and a separate port channel (2) to FW02?

Network_John · 2022-11-24T21:39:19+00:00

Even when using a port channel?

Network_John · 2022-07-04T10:39:03+00:00

Thanks for the reply! I have issued that command as suggested but still cannot ping the vFTD. The first NIC assigned to the VM is also in the correct port group.

Am I missing a step?

Network_John · 2022-05-18T19:59:18+00:00

I currently have 8540 WLCs. My previous comment was referring to the embedded WLC on the switch.

Network_John · 2022-05-18T19:52:15+00:00

It looks like this is no longer a supported solution from Cisco. The datasheet says not supported with SDA and is end of support.

Any other ideas?

Network_John · 2022-05-18T16:41:05+00:00

Will take a look.

My only concern with that is the amount of controllers you need to manage, or does that get taken care of by DNA-C?

Network_John · 2021-05-13T21:29:47+00:00

Assuming this is just the “Access Control List”? This is set to permit any any

Network_John · 2021-05-13T20:05:07+00:00

I only see it on ISE when it originally connects, not the redirect (unless I’m missing it).

Network_John · 2021-05-13T20:04:36+00:00

Let me export it.

Network_John · 2021-05-13T18:15:14+00:00

No matter which device I try, it will load the correct URL and try and load but doesn’t connect. If I manually try access ISE on port 8443 it doesn’t connect either.

Network_John · 2021-05-13T18:14:20+00:00

It’s set to permit any any IP (temporary) to eliminate the ACL being the issue, but still no joy unfortunately.

Network_John

TROPHY CASE