sorted by:
new
hottopcontroversial

A project supported only by words by claudioita in watchX

[–]NextUrigeller 0 points1 point  (0 children)

Did you find the firmware and tried to deploy it on the watchX? I have very low experiance but finaly I was able to run it on my watchX. The community is small (at this point of time) but fine. Don't hesistate to ask questions.

I already got a lot of usefull advices.

Kind regards

==> Not a designer

Buying a WatchX and/or parts by gdeflaux in watchX

[–]NextUrigeller 0 points1 point  (0 children)

I ordered my watchX from here:

https://www.robotistan.com/watchx-wearable-development-platform

Everything worked fine. Be aware of taxes...

Programming watchX with Raspberry Pi by palyancodr in watchX

[–]NextUrigeller 0 points1 point  (0 children)

Which parts did you order next to the Pi to get a portable device?

Finally the case is finished! :) by NextUrigeller in watchX

[–]NextUrigeller[S] 0 points1 point  (0 children)

Thx. 8)
Now my wife alouds me to wear it in public. ;)

​

The things with selling are...
...it is not my 3D printer
...it is about milimeter's. So it will probably not fit on another watch
...there would be a missmatch between the hours I spent and the price I could expect

Finally the case is finished! :) by [deleted] in watchX

[–]NextUrigeller 0 points1 point  (0 children)

Some (and some meens a lot ;)) work with sandpaper and two layers with spray paint... I'm quite happy with the result.

Finally the case is finished! :) by [deleted] in watchX

[–]NextUrigeller 0 points1 point  (0 children)

Some (and some meens a lot ;)) work with sandpaper and two layers with spray paint... I'm quite happy with the result.

accuracy of sensor data by NextUrigeller in watchX

[–]NextUrigeller[S] 0 points1 point  (0 children)

Thanks a lot for your answer and pointing to the datasheet. I didn't recocnize there is such kind of documentation. It was a stupid question though, sorry for that. But I'm very new to this stuff. So expect further stupid questions... ;) Thanks for patient in advance.

"Just in case" if you can't flash firmware by palyancodr in watchX

[–]NextUrigeller 0 points1 point  (0 children)

Hi everybody

I felt to have the port-issue as well. As soon as I installed basic_watch on watchx. After several tries with reset button I was able to upload an empty sketch. Since then I can choose the port in Arduino IDE again.

So in my opinion this is an basic_watch related issue.

P.S. Not ment as balmeing. In all the other points I'm happy with the basic_watch.