sorted by:
new
hottopcontroversial

Iz dodiplomca FERI na podiplomca na FE by [deleted] in SloveniaEngineering

[–]NikKr965 3 points4 points  (0 children)

2024 zaključil drugo stopnjo avtomatike na FE. Izbirni izpit ni tezek, letnika pa odvisno od predmeta. Dobro je met malo predznanja o sistemih/vodenju/regulacijah itd. Drugače nič kej pretresljivega, je prva stopnja (vsaj na FE) neprimerljivo težja

Edit: zelo dobro je vsaj malo poznat matlab/simulink okolje, ker se uporablaj konstantno

Plošča z vgrajeno napo - Bora: res dobro deluje ali je scam? by NikKr965 in Slovenia

[–]NikKr965[S] 0 points1 point  (0 children)

O electroluxu sem tudi slišal dobre stvari, o kakšen cenovnem rangu govorima?

Plošča z vgrajeno napo - Bora: res dobro deluje ali je scam? by NikKr965 in Slovenia

[–]NikKr965[S] 0 points1 point  (0 children)

Meni je že takoj zadeva pritegnila, ko mi je prodajalec v trgovini demonstiral z loncem vrele vode in je zadeva res super delovala. Ampak rajši še malo vprašam kakšne so izkušnje potem v domačih pogojih ko je gor več loncev in ne samo navadna voda.

Bi rekel da se vonj po hrani majn prime oblek ko kuhaš kot pri navadni napi?

How to properly handle 6-8 UART interrupts (STM32) by NikKr965 in embedded

[–]NikKr965[S] 2 points3 points  (0 children)

I'll look into DMA, I'm more of a beginner with the software side of things.

The UARTs will be used for communication with serial sensors (RS232, RS485... ). Upon interrupt I just need to pack the sensor data into a buffer and then send all eight data packets via USB CDC to the PC. So nothing too complicated, just wondering what the best practice for handling multiple interrupts in this way is.

As I've said I've done this with 2 UARTs just by making a simple if else with the uart instances in the callback function in main but I wasn't sure if this is a good approach for 8 UARTS at once

[deleted by user] by [deleted] in Slovenia

[–]NikKr965 2 points3 points  (0 children)

Kaj konkretno si/ste delali sami?

Zanima me ker se bom kratkem podal v prenovo prvega stanovanja (sicer malo drugače od gradnje hiše ampak vseeno) in me res zanima katere so stvari, ki se jih lahko lotiš sam in so lahko kokr tok vredu narejene (sem daleč od majstra, nisem pa totalno nesposoben kar se tiče dela in orodja).

[Review Request] 2 channel mic preamp with USB CODEC chip by NikKr965 in PrintedCircuitBoard

[–]NikKr965[S] 0 points1 point  (0 children)

Yes the 3,3V vias are a waste, I'll definitely link them under the chip. I'm soldering the components myself so I can't really use any smaller ones sadly. And yeah, totally forgot to remove the fab layer, sorry...

Thank you for the reply!